EEWORLDEEWORLDEEWORLD

Part Number

Search

3GPW62B-150M-800.000

Description
LVPECL Output Clock Oscillator, 0.75MHz Min, 800MHz Max, 800MHz Nom, SMD, 6 PIN
CategoryPassive components    oscillator   
File Size125KB,1 Pages
ManufacturerEuroquartz
Websitehttp://www.euroquartz.co.uk/
Environmental Compliance
Download Datasheet Parametric View All

3GPW62B-150M-800.000 Overview

LVPECL Output Clock Oscillator, 0.75MHz Min, 800MHz Max, 800MHz Nom, SMD, 6 PIN

3GPW62B-150M-800.000 Parametric

Parameter NameAttribute value
Is it Rohs certified?conform to
MakerEuroquartz
package instructionDILCC6,.35
Reach Compliance Codecompliant
Other featuresTRI-STATE; ENABLE/DISABLE FUNCTION; COMPLIMENTARY OUTPUT
Maximum control voltage2 V
Minimum control voltage1.3 V
maximum descent time0.7 ns
Frequency Adjustment - MechanicalNO
Frequency offset/pull rate150 ppm
frequency stability50%
Installation featuresSURFACE MOUNT
Number of terminals6
Maximum operating frequency800 MHz
Minimum operating frequency0.75 MHz
Nominal operating frequency800 MHz
Maximum operating temperature70 °C
Minimum operating temperature
Oscillator typeLVPECL
Output load50 OHM
Package body materialCERAMIC
Encapsulate equivalent codeDILCC6,.35
physical size11.4mm x 9.6mm x 2.5mm
power supply3.3 V
Certification statusNot Qualified
longest rise time0.7 ns
Maximum slew rate100 mA
Maximum supply voltage3.465 V
Minimum supply voltage3.135 V
Nominal supply voltage3.3 V
surface mountYES
maximum symmetry55/45 %
EURO
QUARTZ
11.4 x 9.6 x 2.5mm 6 pad SMD VCXO
Frequency range 750kHz to 800MHz
LVPECL Output
Supply Voltage 3.3 VDC
Phase jitter 2.6ps typical (12kHz ~ 20MHz)
Pull range from ±30ppm to ±150ppm
DESCRIPTION
GPW62 VCXOs are packaged in 6 pad 7mm x 5mm SMD. Typical
phase jitter for GPW series VCXOs is 2.6ps. Output is LVPECL.
Applications include phase lock loop, SONET/ATM, set-top boxes,
MPEG , audio/video modulation, video game consoles and HDTV.
SPECIFICATION
Frequency Range:
Supply Voltage:
Output Logic:
RMS Period Jitter:
Peak to Peak Jitter:
Phase Jitter 12kHz to 20MHz):
Initial Frequency Accuracy:
Output Voltage HIGH (1):
Output Voltage LOW (0):
GPW62 PECL VCXO
750.0kHz to 800.0MHz
OUTLINE & DIMENSIONS
750.0kHz to 800.0MHz
3.3 VDC ±5%
LVPECL
4.3ps typical
27.0ps typical
2.6ps typical
Tune to the nominal frequency
with Vc= 1.65 ±0.2VDC
Vdd-1.025V minimum
Vdd-0.880V maximum
Vdd-1.810V minimum
Vdd-1.620V maximum
From ±30ppm to ±150ppm
1.65 ±0.35 Volts
50W into Vdd or Thevenin equiv.
0.5ns typ., 0.7ns max.
20% Vdd to 80% Vdd
50% ±5%
10ms maximum, 5ms typical
25mA max.
65mA max.
100mA max.
2kV maximum
-55° to +150°C
±2ppm per year maximum
Fully compliant
Pulling Range:
Control Voltage Range:
Temperature Stability:
Output Load:
Rise/Fall Times:
Duty Cycle:
Start-up Time:
Current Consumption
<24MHz:
24.01 to 96MHz:
96.01 to 800MHz:
Static Discharge Protection:
Storage Temperature:
Ageing:
Enable/Disable:
RoHS Status:
FREQUENCY STABILITY
PHASE NOISE at 156.250MHz
Offset:
10Hz 100Hz
dBc/Hz:
-62
-92
1kHz
-120
10kHz
-132
100kHz 1MHz 10MHz
-128
-140
-150
PHASE NOISE at 155.520MHz
Offset:
10Hz 100Hz
dBc/Hz:
-60
-90
PART NUMBERING
Example:
1kHz
-115
10kHz
-125
100kHz 1MHz 10MHz
-119
-120
-140
Stability Code Stability ±ppm Temp. Range
A
25
0°~+70°C
B
50
0°~+70°C
C
100
0°~+70°C
D
25
-40°~+85°C
E
50
-40°~+85°C
F
100
-40°~+85°C
If non-standard frequency stability is required
Use ‘I’ followed by stability, i.e. I20 for ±20ppm
ENABLE/DISABLE FUNCTION
Tristate Pad Output Status
Status
Not connected LVPECL and Complimentary LVPECL enabled
Below 0.3Vdd Both outputs are disabled (high impedance)
Above 0.7Vdd
Both outputs are enabled
3 GPW62 B-80N-60.000
Supply Voltage
3 = +3.3V
Series Designator
GPW62
Stability over temperature range
(See table)
Pullability in ±ppm
Pullability determinator
N = minimum
M = maximum
T = Typical
Frequency in MHz
EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE
Tel: +44 (0)1460 230000 Fax: +44 (0)1460 230001 info@euroquartz.co.uk www.euroquartz.co.uk
Analog signal acquisition
[i=s]This post was last edited by dontium on 2015-1-23 13:10[/i] I am a novice and need to make an 8-channel analog signal acquisition system that can collect 0-5V or 4-20mA analog signals. The voltag...
flywingjie Analogue and Mixed Signal
Why is there no waveform output for RC bridge oscillation?
Why is there no waveform output when using RC bridge oscillation? I am using OP07. The feedback is resistor type 473 and 103. The oscillation circuit is capacitor type 104p. The resistor is 393. There...
yeming Embedded System
Altera University Program SD Card Program
I downloaded the IP core of the SD card program for the altera university project , but there is no NIOS program. I wonder if anyone has used it before? Please give it a reference....
tianma123 FPGA/CPLD
Share: A good article on the standard of C language writing
[url=http://www.ouravr.com/bbs/bbs_content.jsp?bbs_sn=434863&bbs_page_no=1&bbs_id=1000]Share: A good article on the standard of C language writing[/url]...
呱呱 Programming Basics
How to set up dsp tms320c5517 uart fifo interrupt?
Dear engineers, hello: I am using dsp --tms320c5517 recently. Since I want to use tx-dma of uart to send, I configured the serial port mode to CSL_UART_FIFO_DMA1_ENABLE_TRIG01. The interrupt trigger l...
zhoujinming DSP and ARM Processors
PWM Problems
I want to output PWM through a single-chip microcomputer and control the speed of the motor according to the duty cycle. How do I do it specifically? How do I set the frequency and how do I implement ...
cattyzeal Embedded System

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 959  2115  678  2  459  20  43  14  1  10 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号