Input Characteristics For Voltage Control Models(Pad1)
Parameter
Control Voltage Range (Vcc = 3.3V)
Frequency Tuning
Linearity
Input Impedance
Slope
(Vc)
Minimum
0.3
±10
±5
100K
Positive
Nominal
1.65
-
-
-
Maximum
3.0
-
-
-
Units
Vdc
ppm
%
Ohm
Notes
7
LVCMOS Output Characteristics
LOAD
Voltage
(High)
(Low)
Current
(High)
(Low)
Duty Cycle at 50% of Vcc
Rise / Fall Time 10% to 90%
Table 7.0
Parameter
(Voh)
(Vol)
(Ioh)
(Iol)
Minimum
-
90%Vcc
-
-4
-
45
-
Nominal
15
-
-
-
-
50
-
Maximum
-
-
10%Vcc
-
4
55
8
Units
pF
Vdc
Vdc
mA
mA
%
ns
Notes
8
Clipped Sinewave Output Characteristics
Load
Output Load Resistance
Output Load Capacitance
Output Voltage (< 40 MHz)
Output Voltage (> 40 MHz)
Table 8.0
Parameter
Minimum
-
-
1.00
0.80
Nominal
10K
10
-
-
Maximum
-
-
-
-
Ohms
pF
V pk-pk
V pk-pk
Units
Notes
9
8
Note
1) TCXO: Initial calibration @ 25°C. Specifications at time of shipment after 48 hours of operation.
2) Frequency change after reciprocal temperature ramped over the operating range. Frequency measured before and after at 25°C.
3) Inclusive of calibration @ 25°C, frequency vs. change in temperature, change in supply voltage (±5%), load change (±5%), reflow soldering process
and 20 years aging.
4) For best in application performance, careful selection of an external power source is critical. Select an external regulator that meets or exceeds to
following specifications regarding voltage regulation tolerance, initial accuracy, temperature coefficient, voltage noise, and low voltage noise density
Factory Test Conditions:
Initial Accuracy ±2mv, Noise (0.1Hz to 10 KHz) 15uV p-p, Voltage Noise Density = 50nV/srt Hz, Temperature Coefficient
< 5ppmºC.
5) Phase noise measurements Fo = 20 MHz, other frequencies may vary by 20log F/20MHz.
6) Typical start up time for the frequency range of 12.8 MHz to 25 MHz <330 us.
7) Additional pull ranges are available; please contact the factory for additional information.
8)
Attention: To achieve optimal frequency stability, and in some cases to meet the specification stated on this data sheet, it is required that the circuit connected to
this T CXO output must have the equivalent input capacitance that is specified by the nominal load capacitance. Deviations from the nominal load capacitance will
have a graduated effect on the stability of approximately 20 ppb per pF load difference.
The intrinsics provided by the C6000 compiler can quickly optimize C code. The leading underscore of an intrinsic indicates that it can be called just like a function, that is, it is directly inlined ...
I have set LPT1 to ECP, address: 0378H, but it still doesn't work. Every time I start C-SPY after compiling, it pops up: C-SPY FATAL ERROR: fatal error[60]: "Could not obtain device identification!" I...
I built the typical circuit in the datasheet, with a 3.6V input voltage regulator and a 16 ohm load, and the output is only 3.0V. The capacitors used are ceramic chip capacitors. The two 2.2uf are in ...
Raw-OS (www.raw-os.com) took off in 2012. Raw-OS aims to create a Chinese-owned, open-source, free real-time operating system. Raw-OS philosophy: stable, efficient, portable, open-source. We hope that...
I would like to ask if I should set TCCR1B to zero to stop timer 1? Is it OK to set TCCR1A to zero? Why do the two effects look the same when I try it on the experiment board?...
UHF and HF are both general technology categories, but each category has independent supporting protocols. HF is more consistent in the 13.56MHz frequency band, although there are many internation...[Details]
1 Overview
Drugs are like a "double-edged sword". They can treat diseases but can also cause serious adverse consequences. The dual nature of drugs depends on whether they are used rationally....[Details]
Medicines are special commodities. If patients are given the wrong medicine, fake medicine, inferior medicine or expired medicine, it will pose a threat to people's health and lives.
In recent...[Details]
1 Overview
The BP01 pressure sensor is specially designed for monitoring blood pressure and is mainly used in portable electronic sphygmomanometers. It uses a precision thick-film ceramic chip and...[Details]
Many medical applications require portable, self-powered devices that do not require external power and data cables. The most obvious example is a portable data logger that patients carry with them to...[Details]
0 Introduction to the direct method of feedback linearization based on dynamic equilibrium state theory
The basic idea of the direct method of feedback linearization based on dynamic equilib...[Details]
Compared with traditional light sources, light-emitting diodes (LEDs) have many advantages, such as low operating voltage, high energy efficiency, small size and directional light. They can provide...[Details]
Volkswagen's electronic throttle has taken our understanding of the traditional throttle a big step forward. However, while we admire Volkswagen's new technology, which is constantly being applied...[Details]
1 Introduction
Generally, when transmitting information over short distances through electrical signals, baseband signals can be directly transmitted. However, over long distances, baseban...[Details]
With the improvement of people's requirements for vehicle riding comfort and the development of passenger car suspension technology in my country, air suspension is increasingly used in passenger ...[Details]
The third generation iPhone, iPhone 3G S, has finally been released. Let's take a look at the differences in basic parameters between it and the previous generation iPhone 3G.
According to for...[Details]
Faced with increasingly fierce market competition and increasingly picky users, automakers and auto parts suppliers have been working hard to innovate - products with newer technological content an...[Details]
With the increasing application of various nonlinear loads, reactive power and harmonic pollution in the power grid have become a very serious problem. In order to eliminate the pollution caused by...[Details]
0 Introduction
Cadence Design Systems Inc. is the world's largest provider of electronic design technology, program solutions and design services. Its solutions are designed to enhance and...[Details]
0 Introduction
In the multimedia era, traditional Class A, Class B, and Class AB linear analog audio amplifiers can no longer meet the new development trends of green energy saving, high e...[Details]