-
In the past few days, the news that ZTE was "banned" by the US Department of Commerce has triggered widespread reflection and concern in various domestic industries about the lack of independent co...[Details]
-
I recently upgraded MDK to V5.25 and found that there are many libraries in the Managing Run-Time Environment. Compared with the past, it is much better, from the bottom-level driver to the upper-le...[Details]
-
Different from 51, AVR and other single-chip microcomputers, the clock signal sources of msp430 include LFXT1, XT2 and DCO. 1. LFXT1: It can connect high-speed and low-speed crystal oscillators. In l...[Details]
-
The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]
-
On May 16, in response to
the public opinion storm caused by
Lenovo's
"
5G
voting" incident,
Lenovo
Holdings Chairman and
Lenovo
Group Founder Liu Chuanzhi, Lenovo Gr...[Details]
-
1. Heart rate measurement principle 1. What is a heart rate module? The heart rate module is professionally used to monitor the heart rate of the wrist, fingers, forehead, earlobe, chest and other ...[Details]
-
pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t AD_Channel) { hadc.Instance- CHSELR = 0; ADC_ChannelConfTypeDef sConfig; sConfig.Channel = AD_Channel; sConf...[Details]
-
The photovoltaic industry has become a new business card for China to the world. It not only represents China's leading technology, but also constantly breaks various records with its development spee...[Details]
-
Pin Definition FSMC configuration steps 1. Enable the corresponding pin GPIO clock 2. Configure the GPIO pin mode 3. Enable the FSMC clock 4. FSMC initialization 5. Memory block enable Examp...[Details]
-
;Question: The 80C51 single-chip microcomputer has a fosc = 6MHz. It is required to use the T1 timer working mode 1 to perform a timing of 40ms. And P1.7 periodically outputs a rectangular wave with ...[Details]
-
Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]
-
/****************************************************************** ** ** File : DExternInterrupt.c | Interrupt | ...[Details]
-
#include avr/io.h #include avr/interrupt.h int main() { DDRB|=0X20;//Set PWM waveform output, connected to port PB5, see the comment of OCR1A=15625 for details DDRE=0X04; PORTE=0X04; DDRA=0XFF; P...[Details]
-
#include avr/io.h #include util/delay.h #include avr/interrupt.h //Interrupt function header file //Function declaration void Port_Init(void); //Port initialization configuration void Comp...[Details]
-
The watchdog timer is a counter whose basic function is to restart the system after a software problem or program runaway occurs. The watchdog counter counts automatically when it is working normally...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
