Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
by Aimtec; refer to www.aimtec.com for the most current product specifications.
2.
Product labels shown, including safety agency certifications on labels, may vary based on the
date manufactured.
3.
Mechanical drawings and specifications are for reference only.
4.
All specifications are measured at an ambient temperature of 25°C, humidity<75%,
nominal input voltage and at rated output load unless otherwise specified.
5.
Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.
6.
This
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet.
7.
Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com.
[i=s] This post was last edited by paulhyde on 2014-9-15 09:37 [/i] I built a 297 according to the typical circuit, but it oscillates. Can anyone give me some advice?...
Zener diodes are often represented by "ZD" plus a number in circuits, such as: ZD5 represents the Zener diode numbered 5. What should we do when using it?...
As soon as the development board arrived, I powered it up and tried it out. I thought it would be the same as the Espressif products I used in the past. I just connected it to the UART port and sent A...
When WinCE5.0 builds the system, the following error occurs: BUILD: [01:0000000913:ERRORE] NMAKE: U1073: don't know how to make 'D:\WINCE500\platform\common\lib\ARMV4Ietail\oal_memory_s3c2440a.lib' BU...
Why does an error message appear when I install CCS? The operating system is 64-bit Windows 7, and before installing the last component, a message like Figure 1 appears:What's up with this prompt?Rega...
Electronics Design Contest
京公网安备 11010802033920号
EEWORLD
