AM1L-0303S-NZ

The global PV inverter market will shrink from $6.3 billion in 2017 to $3.7 billion in 2022 due to falling prices, according to GlobalData. Global PV Inverter Market Value to Shrink to $3.7 Bil...[Details]

Hardware platform: stm32F407Zet6 Software platform: stm32cubeMX 4.7+MDK5.14 Circuit connection: PE8-LED0, PE9-LED1, PE10-LED2, PE11-LED3 Step 1: Create a project using stm32cubeMX 1. Start the soft...[Details]

This small program is still the use of timer, which is relatively simple. The specific parts are noted in the comments, please refer to the comments. /*********************************************...[Details]

    The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]

pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t  AD_Channel)   {          hadc.Instance- CHSELR = 0;       ADC_ChannelConfTypeDef sConfig;       sConfig.Channel = AD_Channel;           sConf...[Details]

Introduction: As a power electronic device, the photovoltaic inverter mainly converts the direct current generated by the photovoltaic module into alternating current. Because there are thousands o...[Details]

The pins of stm32 have two uses: GPIO (general purpose io) and AFIO (alternate function io) For some pins (depending on the chip), neither of these two uses exists. For example, in 64-pin products, O...[Details]

Pin Definition  FSMC configuration steps 1. Enable the corresponding pin GPIO clock  2. Configure the GPIO pin mode  3. Enable the FSMC clock  4. FSMC initialization  5. Memory block enable Examp...[Details]

I have encountered many problems when tinkering with LD driver recently. I will record them one by one below. Otherwise, who will remember who in five hundred years? 1. Configuration issues of multi-...[Details]

#include reg52.h      #include intrins.h          //unsigned char segout ={0,1,2,3,4,5,6,7}; //8 columns   unsigned char segout ={0x01,0x02,0x04,0x08,0x10,0x20,0x40,0x80}; //8 columns   unsigned char...[Details]

Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]

;The hardware connection circuit of the 51 single-chip microcomputer is as follows: ;P1.3 and P1.4 are each connected to a button; ;P0.0 and P0.3 are each connected to a light-emitting diode; ;P2.0~P...[Details]

　　After the first public release of the prospectus of CATL, a new vitality was injected into new energy vehicles. According to market speculation, CATL is expected to issue at around 60 yuan per shar...[Details]

    Each I/O port of the AVR microcontroller corresponds to three registers: DDRx, PORTx and PINx, where DDRx is the data direction, i.e. input or output; PORTx is the state of the internal pull-up r...[Details]

MSP430 MCU Stepper Motor Program #include "msp430x22x4.h"  #define uchar unsigned char  #define uint unsigned int  uchar i=0;  // Scanning 4x4 keyboard #define keyin (P2IN&0x0F)  //digital tube v...[Details]