battery-derived AC output during brownouts and power failures with enough runtime to save and shutdown
environment
Package Includes
ECO750UPS UPS System
USB cable
Instruction manual
connected equipment without data loss. Offers complete protection in an ultra-compact desktop or wall-mountable housing. Includes 6 battery supported
outlets for computer, monitor and four vital system peripherals, plus 6 additional surge suppression-only outlets for accessories not requiring battery support.
Four of the surge-only outlets are designated Eco outlets that can be configured to automatically power-off when the computer enters standby mode or is
shutdown. USB port enables UPS configuration options and unattended system shutdown without data loss in the case of extended power failure. PowerAlert
software is available via free download from www.tripplite.com. USB cable included. Built-in single line RJ11 phone suppression protects modem, fax machine,
cordless phone or other accessories with a dialup/DSL phone connection. Built-in audible alarm and front panel LEDs offer continuous status information
regarding line and battery power operation. 750VA/450 watt UPS output capacity with up to 34 minutes runtime for an entry-level PC with small LCD monitor
ECO750UPS standby green UPS offers complete protection from blackouts, brownouts and transient surges
Built-in Eco outlets automatically power off unnecessary computer accessories like printers, scanners and speakers when computer is not in use
Full load efficiency rating of 99% saves energy and heat output by limiting UPS power consumption to less than 5 watts with only 4 BTU/hr. of heat output
Hello experts, I am a newbie to cortex-M0 and I have a problem. It is an LPC1114 board. It is the same hardware environment, but two different codes with different functions. One simulation goes smoot...
When programming 2812, for example, there is such a situation: int a, int b, I want to perform a shift operation (a×b)>>9, but a×b has overflowed, so is the result correct after the shift? And what ab...
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 19:51[/i] Introduction: Each Arduino product is actually an expansion and integration of various functions of the Arduino minimum system. ...
Open-Drain means open-drain output, which is equivalent to open-collector output, that is, open-collector (OC) output in TTL. It is generally used for line-OR, line-AND, and some are used for current ...
Recently, the teacher asked me to make an eight-way display with a queuing function! ! It is required to be implemented with a digital circuit or a single-chip microcomputer. The main problem now is t...
NXP MCU
京公网安备 11010802033920号
EEWORLD
