1. Modify the registry. Through the tool, you can see that I have successfully modified the value of \ControlPanel\BackLight\Brightness. Then HANDLE hBL=CreateEvent(NULL,FALSE,FALSE,L"BackLightChangeE...
[size=4] Dedication is everywhere, the circuit diagram of the nail art of a female electronic engineer. Do you have similar dedicated electronic engineers around you? :lol Please post a photo in the t...
A small magnet is placed on the end face of the motor shaft, close to the edge. When the motor starts, the Hall sensor outputs a signal. This signal is used to control the start and stop of the subseq...
I use MSP430 to send data to PC, and I can receive the data using the serial port assistant, but I can't display the data using VC++. The following is the control receiving code (the control can commu...
I am now training driver chips during the summer vacation. I try not to look at other people's manuals. Is it interesting? It takes a long time. I don't know if it is a waste of time. I don't know how...
I downloaded "Keystone 1 SPI NOR boot steps and precautions" and routines. I used cs1 on my board. After burning the flash, I started in spiboot mode and found that the chip select was always on cs0. ...