Surface Mount Multilayer Ceramic Chip Capacitors, (SMD MLCCs)
High Voltage X7R Dielectric, 500VDC–3000VDC (Commercial & Automotive Grade)
Qualification/Certification
Commercial Grade products are subject to internal qualification. Details regarding test methods and conditions are referenced in
Table 4, Performance & Reliability.
Automotive Grade products meet or exceed the requirements outlined by the Automotive Electronics Council. Details regarding test
methods and conditions are referenced in document AEC-Q200, Stress Test Qualification for Passive Components. For additional
information regarding the Automotive Electronics Council and AEC-Q200, please visit their website at www.aecouncil.com.
Environmental Compliance
Pb-Free and RoHS compliant (excluding SnPb termination finish option)
Electrical Parameters/Characteristics
Item
Operating Temperature Range
Capacitance Change with Reference to +25°C and 0 VDC Applied (TCC)
Aging Rate (Max % Cap Loss/Decade Hour)
Dielectric Withstanding Voltage
Dissipation Factor (DF) Maximum Limit @ 25ºC
Insulation Resistance (IR) Limit @ 25°C
-55°C to +125°C
±15%
3.0%
150% of rated voltage for voltage rating of < 1,000V
120% of rated voltage for voltage rating of ≥ 1,000V
(5 ± 1 seconds and charge/discharge not exceeding 50mA)
2.5%
See Insulation Resistance Limit Table
(500VDC applied for 120 ± 5 seconds @ 25°C)
Parameters/Characteristics
Regarding aging rate: Capacitance measurements (including tolerance) are indexed to a referee time of 1,000 hours.
To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.
Capacitance and dissipation factor (DF) measured under the following conditions:
1kHz ± 50Hz and 1.0 ± 0.2 Vrms if capacitance ≤10µF
120Hz ± 10Hz and 0.5 ± 0.1 Vrms if capacitance >10µF
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as
Automatic Level Control (ALC). The ALC feature should be switched to "ON."
KEMET reserves the right to substitute product with an improved temperature characteristic, tighter capacitance tolerance and/or higher voltage capability within
the same form factor (configuration and dimensions).
The noise of hydraulic transmission system is generated by the closed circuit composed of motor, hydraulic pump, valve auxiliary device and hydraulic pipeline. Because in this closed circuit system, t...
Use 4 1N4148s to build a rectifier bridge, input a 50Hz sine wave model with an amplitude of 10-20Vp-p. Due to the existence of the forward conduction voltage of the diode and the low amplitude of the...
Use the timer function of the 51 microcontroller to make a clock, AT24C02 stores the time, and after power failure, it can still display the time when the power is turned on again. What applications c...
I use 2812 and XR16L784 to expand 4 serial ports. Now there is no problem to access registers through bus settings. But I just can't send data. I don't know what's going on?My initialization program i...
I have been working on this i2c for several days. Many people on the Internet say that this is a problem with the ST package library, and they basically talk about the STM32F1 series of chips, and ev...[Details]
Recently, the relevant person in charge of the Energy Conservation Division of the Energy Conservation and Technology Equipment Department of the National Energy Administration said on the issue of...[Details]
In the development of artificial intelligence, talent reserve is undoubtedly an important part. Artificial intelligence should be a bottom-level technology that can be deeply embedded in any indust...[Details]
Since China began to try to produce panels independently in 1998, in 2018, China's panel industry has gradually upgraded from a marginal industry to the largest production scale. Especially in the ...[Details]
I rewrote the main part of this program. The program uses the watchdog as a normal timer and scans the digital tubes in the watchdog interrupt. In addition, I added a display buffer. If you want to d...[Details]
Different from 51, AVR and other single-chip microcomputers, the clock signal sources of msp430 include LFXT1, XT2 and DCO. 1. LFXT1: It can connect high-speed and low-speed crystal oscillators. In l...[Details]
First of all, security practitioners have never felt that AI can be used as deeply as today. Although Antelope Cloud is a platform manufacturer, it has always been interested in AI and AI- specific...[Details]
The day before yesterday, another mainland technology company submitted a prospectus to the Hong Kong Stock Exchange. The company is called "Jia Nan Creative (hereinafter referred to as 'Jia Nan')"...[Details]
Different models of PIC series microcontrollers have different watchdog settings. The following takes the PIC16F688 microcontroller as an example. 1. If WDTE=1 in the configuration word, the watchdog...[Details]
Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]
****************************************************************** 1. The operand is in register, R0--R7 2. Operands are in internal RAM 3. Operands are in external RAM But they are all similar. For ...[Details]
;Question: The 80C51 single-chip microcomputer has a fosc = 6MHz. It is required to use the T1 timer working mode 1 to perform a timing of 40ms. And P1.7 periodically outputs a rectangular wave with ...[Details]
One addend is in the on-chip RAM 40H, 41H, 42H units, the other addend is in the on-chip RAM 43H, 44H, 45H, and the sum is stored in the 50H, 51H, 52H units, with the carry bit stored in 00H. Please ...[Details]
The concept of AI is general and covers a wide range. What is the core of AI? Let's follow the network communication editor to learn about the relevant content.
On May 8, local time in the...[Details]
//******************************************************************************/ #include msp430.h //Note: There must be a delay between two transmissions, otherwise it cannot be sent again, seria...[Details]