* Overload Voltage=2.5*√(P*R) or Max. overload voltage listed above, whichever is lower.
G and J Tol.: ±200 (1Ω - 10 Meg
Ω);
F and D Tol.: ±100 (10Ω - 1 Meg
Ω);
±200 (1Ω
- 9.76Ω)
& (1.02 Meg
Ω
- 9.76 Meg Ω); D, F, G & J Tol.: ±350 (10 Meg Ω and over)
T.C.R. is ±350 for values outside referenced range. 0201 case size: ±200 for F and J Tol (10Ω - 1 Meg Ω). 01005 case size: ±250 for (10Ω - 1 Meg Ω); +600 - -200 for
(4.7-9.1Ω). TCR is ±350 for values outside referenced range.
Operating Temp. Range is -55°C to +155°C • DC Resistance Value of zero ohm is 50m ohms max.
[i=s] This post was last edited by dontium on 2015-1-23 11:11 [/i] [font=宋体][size=10.5pt] [/size][/font][size=5][font=宋体] The first chapter mainly introduces three methods of noise analysis: time doma...
[i=s]This post was last edited by qq849682862 on 2015-12-21 14:25[/i] The 34138A is a banana-shaped test probe designed for high-precision digital multimeters. It is compatible with 34401A, 34405A, 34...
[color=#333333][font=Arial] [/font][/color] [color=#333333][font=Arial]Briefly introduce the legendary artifact (said to be the "performance monster" among development tools): [/font][/color] [color=#...
[i=s]This post was last edited by qwqwqw2088 on 2020-3-28 10:16[/i]Lithium coin/button battery
The lithium battery is 3V under load and 3.6V without load.Silver oxide and alkaline button cell batterie...
The rapid development of the Internet has realized high-speed information transmission and resource sharing, greatly facilitating people's lives. Embedded systems are widely used in various electr...[Details]
introduction
In the discharge process of tokamak plasma physics, the study of rupture and sawtooth is of great significance. Rupture and sawtooth exist in most tokamaks. Rupture is a notew...[Details]
introduction
Solar cells and LED lighting are typical applications of new energy and energy-saving and efficient technologies. Solar LED lighting uses solar cells to convert solar energy...[Details]
Since the No. 4 blast furnace of Handan Iron and Steel was put into operation in 1993, its external equipment has been seriously aged, and the original PLC control system TDC3000 of the hot blast furn...[Details]
The concept of state machine
State machine is an important concept in software programming. More important than this concept is its flexible application. In a clear and efficient program, ther...[Details]
According to the Industrial Technology Research Institute of Taiwan, due to factors such as the oil crisis and global warming, the issues of energy conservation and environmental protection have at...[Details]
hint:
The number of speakers and their spacing limit the sound field of a portable stereo system.
Spatial audio attempts to artificially recreate the experience of listening to sounds i...[Details]
The TPS92210 is a single-stage LED lighting pulse width modulation (PWM) controller. The TRIAC dimmable solution not only regulates the LED current, but also achieves a power factor close to 1. The...[Details]
Only a small number of LED manufacturers can produce high-quality LEDs. For applications that are only used for simple indication, low-quality LEDs are sufficient. However, high-quality LEDs must...[Details]
Since AC mains power may experience power outages, voltage sags and surges, continuous undervoltage and overvoltage, and frequency fluctuations during supply, these factors will affect the continuous ...[Details]
System Overview
The system consists of a signal preprocessing circuit, a single-chip computer AT89C2051, a systematic LED display module, a serial port data storage circuit and system software...[Details]
1 Basic Features
In computer control systems and various intelligent instruments and meters composed of single-chip microcomputers (or microprocessors), various external analog signals must be ...[Details]
1. Introduction
With the increasing popularity of fully automatic washing machines, consumers have higher and higher requirements for their environmenta...[Details]
A few days ago, I bought an 8LED flashlight in the market (the flashlight uses No. 5 batteries). Because I had other things to do, I didn't pay attention when purchasing it. When I got home and use...[Details]
This article discusses the six design steps of LED lighting system design in detail: (1) determine the lighting requirements; (2) determine the design goals and estimate the optics; (3) the efficie...[Details]
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
