90121-0145

On April 24, Sungrow released its annual financial report. The report shows that in 2017, Sungrow's global shipments reached 16.5GW, of which domestic shipments reached 13.2GW, a year-on-year incre...[Details]

Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode.  Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows:  ...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

Serial Port:   一. USART_ITConfig(USART1, USART_IT_TXE, ENABLE): As long as the transmit register is empty, there will always be an interrupt. Therefore, if you are not sending data, turn off the tran...[Details]

This program mainly uses the comparison output function of the timer to generate PWM waves to control the LED. The comparison output of timer A corresponds to P2.3 P2.4. Therefore, a matching working...[Details]

In the project, CPLD is needed to complete part of the algorithm design. The parameters are given by AVR, so the communication between AVR and CPLD needs to be completed. Therefore, a test program is...[Details]

    1. Brief description     A summary of "How to build uClinux kernel transplantation on ARMSYS development board with S3C44B0X as core", including the analysis of Bootloader function and the key co...[Details]

In 1949, after three years of civil war, the Nationalist government was defeated and retreated to Taiwan. The political and academic circles launched a large-scale reflection on why they failed in ...[Details]

Use the STM32 timer input capture module to control 3-way ultrasonic sensors. The  ultrasonic sensor used this time is the common HC-SR04, which is often used in the obstacle avoidance system of smal...[Details]

OSC_IN and OSC_OUT are external crystal pins by default. If you do not use an external crystal oscillator on the STM32, how to connect OSC_IN and OSC_OUT If you use the internal RC oscillator instead...[Details]

The code for using timer 0 to implement a running light in a 51 MCU is as follows. The LED light is connected to port P1. The code is annotated below, so I won't explain it in detail. My English is n...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]

#include "MSP430x24x.h" void main(void) {         // Stop watchdog timer to prevent time out reset         WDTCTL = WDTPW + WDTHOLD; //Watchdog            P4DIR = BIT0|BIT1|BIT2|BIT3; //Set to outpu...[Details]

/********************************************************************** **                                                        ** File : EEPROM.c | Eeprom write and read |                         ...[Details]

　　According to a report by Russian News Agency on November 23, Alexander Hanin, founder and general manager of VisionLabs, a Russian facial recognition software development company, believes that in ...[Details]