This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI. No part of the information shown on the document may be used in any way or
disclosed to others without the written consent of FCI.
Copyright FCI.
Form E-3727
Rev A
PDS: Rev :A
STATUS:Released
GS-01-001
Printed: Nov 29, 2012
NUMBER
TYPE
GS-20-0355
TITLE
Application Specification
PAGE
REVISION
2 of 9
A
DATE
BTFW シリーズ（1.0mm 千鳥ﾋﾟ½ﾁボード to ボードコネクタ）
BTFW series (1.0mm staggered pitch Board to Board connector)
AUTHORIZED BY
M.Koga
CLASSIFICATION
9/18/2012
UNRESTRICTED
3. 各部名称
3. Each part name
プラグコネクタ / Ｐ½½½ connector
リセプタクルコネクタ/Receptacle
connector
ハウジング
Housing
ハウジング
Housing
コンタクト
Contact
補強金具
Fixing Tab
コンタクト
Contact
補強金具
Fixing Tab
This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI. No part of the information shown on the document may be used in any way or
disclosed to others without the written consent of FCI.
Copyright FCI.
Form E-3727
Rev A
PDS: Rev :A
STATUS:Released
GS-01-001
Printed: Nov 29, 2012
NUMBER
TYPE
GS-20-0355
TITLE
Application Specification
PAGE
REVISION
3 of 9
A
DATE
BTFW シリーズ（1.0mm 千鳥ﾋﾟ½ﾁボード to ボードコネクタ）
BTFW series (1.0mm staggered pitch Board to Board connector)
AUTHORIZED BY
M.Koga
CLASSIFICATION
9/18/2012
UNRESTRICTED
4. 実装方法
4. Mounting method
4.1 推奨基板パターン
4.1 Recommended PCB layout
弊社発行 適用½品図面を参照願います。
Refer to drawings
4.2 基板実装方法
4.2 Mounting method of the connector on the PCB
自動実装・表面実装対応のタイプは、自動実装機により基板へ装着し、リフローはんだ付けを
行ってください。
Automatic mounting and SMT type proceeds reflow soldering after mounting it on the PCB
by automatic mounting machine.
ディップタイプは、基板に挿入後フロー半田付けを行ってください。
Dipping type proceeds flow soldering after inserting into the PCB
1) Please take care hand soldering of rework to prevent penetrating flux on to the contacting portion.
2) Please take care hand soldering of rework, do not apply external force to the contact lead section at
the soldering iron point.
3) Please do not solder when connector is mated condition.
4) Please do not touch the contact portion by hand.
5) Please control warpage of PCB. Soldering may become poor, if PCB warpage is large.
6) Please do not give the external force beyond 0.5N to a connector before mounting.
Connector may be damaged.
7) Do not apply any forces affecting soldered joints when PC Board cut off multiple board and screw
cramp of board etc.
This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI. No part of the information shown on the document may be used in any way or
disclosed to others without the written consent of FCI.
Copyright FCI.
Form E-3727
Rev A
PDS: Rev :A
STATUS:Released
GS-01-001
Printed: Nov 29, 2012
NUMBER
TYPE
GS-20-0355
TITLE
Application Specification
PAGE
REVISION
4 of 9
A
DATE
BTFW シリーズ（1.0mm 千鳥ﾋﾟ½ﾁボード to ボードコネクタ）
BTFW series (1.0mm staggered pitch Board to Board connector)
AUTHORIZED BY
M.Koga
CLASSIFICATION
9/18/2012
UNRESTRICTED
5. 取扱上の注意
5. Cautions for operation
5.1 嵌合許容量
5.1 Mating allowance
(1) X 方向許容量
：±0.5mm 以内
(1) X direction allowance ：±0.5mm max.
嵌合許容量：+0.5mm
max.
Mating allowance: +0.5mm max.
嵌合許容量：-0.5mm
max.
Mating allowance: -0.5mm max.
Center condition
This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI. No part of the information shown on the document may be used in any way or
disclosed to others without the written consent of FCI.
Copyright FCI.
Form E-3727
Rev A
PDS: Rev :A
STATUS:Released
GS-01-001
Printed: Nov 29, 2012
NUMBER
TYPE
GS-20-0355
TITLE
Application Specification
PAGE
REVISION
5 of 9
A
DATE
BTFW シリーズ（1.0mm 千鳥ﾋﾟ½ﾁボード to ボードコネクタ）
BTFW series (1.0mm staggered pitch Board to Board connector)
AUTHORIZED BY
M.Koga
CLASSIFICATION
9/18/2012
UNRESTRICTED
(2) Y 方向許容量
：±0.4mm 以内
(2) Y direction allowance ：±0.4mm max.
嵌合許容量：+0.8mm
max.
Mating allowance: +0.8mm max.
嵌合許容量：-0.8mm
max.
Mating allowance: -0.8mm max.
Center condition
(3) Z 方向許容量
：±0.5mm 以内
(3) Z direction allowance ：±0.5mm max.
嵌合許容量：+0.5mm
max.
Mating allowance: +0.5mm max.
嵌合許容量：-0.5mm
max.
Mating allowance: -0.5mm max.
Center condition
This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI. No part of the information shown on the document may be used in any way or
disclosed to others without the written consent of FCI.
Direct reasons for fuse blowing in switching power supply: switch tube\power thick moduleectifier diode breakdown\100uf/400v large capacitor breakdown leakage, demagnetization resistor internal fragme...
How to Estimate the Q of an LC Circuit
Time: 2010-06-17 18:48:22 Source: Author:Figure 3.4 shows a resistor in series with the signal source. This resistor can be used as a model for the output impeda...
1 Overview When driving at high speed, tire failure is the most worrying and difficult to prevent for all drivers, and is also an important cause of sudden traffic accidents. According to statistics, ...
Table of contentsMM32F5270 bus architectureExample: Audio player with displaySummaryNextThe previous article introduced the " Star" STAR-MC1 processor used in the MM32F5 series . If readers still reme...
The TIA Portal software's shift instructions shift the contents of an accumulator bit by bit to the left or right. The number of bits shifted is determined by N. A left shift of N bits multiplies t...[Details]
EtherCAT (Ethernet for Control Automation Technology) is a real-time industrial fieldbus communication protocol based on an Ethernet-based development framework. EtherCAT is one of the fastest indu...[Details]
As time goes by, people are increasingly concerned about their own and their families' health. However, existing monitoring devices for individual vital signs have struggled to gain market share du...[Details]
On August 25th, Apple's expansion in India encountered new troubles. According to Bloomberg, Foxconn Technology Group has recalled approximately 300 Chinese engineers from India, further hindering ...[Details]
On August 18th, Galaxis, a specialist in integrated intelligent intralogistics robotics, officially unveiled its next-generation, ultra-narrow aisle forklift mobile robot, the "VFR Ultra-Narrow Ser...[Details]
introduction
Sonar imaging is of great significance in marine resource development and defense. Its long range, intuitive display of the observed area, and target identification make it widely...[Details]
A half-bridge is an inverter topology for converting DC to AC. A typical half-bridge circuit consists of two controller switches, a three-wire DC power supply, two feedback diodes, and two capacito...[Details]
Preface
Low-voltage motors are widely used in nonferrous metallurgical plants. Their abnormal operation not only impacts normal production but can also threaten human life. Therefore, providin...[Details]
Batteries, at the core of new energy vehicles, are crucial to vehicle performance and range. Existing automotive batteries are categorized into lead-acid and lithium batteries. Currently, new energ...[Details]
Puttshack's Trackaball uses the Nordic nRF54L15 system-on-chip (SoC) to monitor sensors and enable Bluetooth low energy connectivity, while the nPM2100 power management integrated circuit (PMIC) ...[Details]
introduction
The widespread use of air conditioner communication circuits began with the rise of household inverter air conditioners. With China's energy conservation and emission reduction in...[Details]
introduction
The rapid development of science and technology has enabled mankind to quickly move from the Internet era to the big data era. As a result, the amount of data generated by people ...[Details]
0 Introduction
DVI (Digital Visual Interface) is a hot topic in current digital display research and application. Video processing technologies for DVI output not only address issues such as h...[Details]
On August 20, it was reported that the specifications of Intel's upcoming Panther Lake mobile processor appeared on the Intel GFX CI website, which mainly focuses on Intel's open source Linux drive...[Details]
0 Introduction
Portable terminals integrate a computer and display screen into a single device. Due to limited space in portable devices, previous designs often used a single-chip microcompute...[Details]
LED Zone
京公网安备 11010802033920号
EEWORLD
