240-383EP11-99PPPBNN

Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]

All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]

The reason for the light decay of white LEDs: the decline of phosphor performance So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]

1. Introduction At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]

Overview: This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network. CAN (Controller Area Network) is ...[Details]

Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]

The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors. The output voltage is switched on and off at a high frequency, control...[Details]

1. Proposal of reconfigurable measurement and control system The measurement and control system generally refers to a system based on computers to realize data acquisition a...[Details]

A stepper motor is an electromagnetic mechanical device that converts an electrical pulse signal into an angular displacement or a linear displacement. The stability and reliability of a stepper mo...[Details]

0 Introduction In the design and construction of communication systems, communication power supply is called the heart of the communication system. The power supply system will dire...[Details]

LonWorks fieldbus technology is widely used, for example, in intelligent buildings, industrial control, environmental protection, etc. Echelon's LonWorks system has been used in the products of tho...[Details]

TMC428 is a stepper motor motion controller from TRINAMIC. It can reduce the workload of motor control software design and development costs. The 3-axis stepper motor drive control system based on ...[Details]

UDN2916LB is a two-phase stepper motor bipolar driver integrated circuit launched by SANKEN. It can drive dual-winding bipolar stepper motors and is particularly suitable for controlling dual-step ...[Details]

SL11R is a 16-bit RISC microcontroller with a USB interface produced by Scanlogic. Its core processing speed reaches 48MIPS. It has rich hardware resources and 32-bit programmable I/O ports, and ca...[Details]

For the past 15 years, many have predicted that the 8 -bit microcontroller would soon be gone. However, this was one of the most miscalculated predictions in the el...[Details]