Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3.
Phase noise degrades with increasing output frequency.
4. Subject to technical modification.
5.
Contact factory for availability.
For Additional Information, Please Contact
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
USA:
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Europe:
Vectron International
68 Yin Cheng Road(C), 22nd Floor
One LuJiaZui
Pudong, Shanghai 200120, China
Tel: 86.21.6194.6886
Fax: 86.21.6194.6699
Asia:
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
Does anyone have this platform built with IAR? Could you please send me a copy? I would be grateful...Dear friends , I want to transplant ucos2 to stm32 to further learn embedded operating systems.I a...
I bought the Hall Effect chip A3144 from Zhongfa. When testing, the output signal of some chips could not go down when it should be low. The lowest was 2.5v, and the power supply was 5v. Why? I found ...
Masters, when the fuse is blown, the P1.0 port should be directly pulled to a low level. If the fuse is blown, will P1.0 be at a high level after power-on?...