C132272JX7R5LF

In our common sense, the word technology often has two definitions. The first is the technology sealed in the laboratory. They are like flowers on the mountain top. Only a few people on the mountai...[Details]

1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows:  The output is as follows:  It can...[Details]

1. Purpose         In actual product release, if the program stored in the MCU Flash is not protected, some illegal companies may read the program in the Flash through an emulator (J-Link, ST-Link, e...[Details]

Hardware platform: stm32F407Zet6 Software platform: stm32cubeMX 4.7+MDK5.14 Circuit connection: PE8-LED0, PE9-LED1, PE10-LED2, PE11-LED3 Step 1: Create a project using stm32cubeMX 1. Start the soft...[Details]

background After the hardware engineer completed the PCB and schematic design, the routine was modified according to the tutorial of Zhengdian Atom to verify the correctness of the hardware.  STM32F...[Details]

　　Nowadays, everyone is saying that "technology is people-oriented". The essence of the development of technology is to serve the improvement of the quality of life of human beings. Automated driving...[Details]

What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

Introduction: As a power electronic device, the photovoltaic inverter mainly converts the direct current generated by the photovoltaic module into alternating current. Because there are thousands o...[Details]

The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are:  1. User Flash = Flash built into the chip   2.SRAM = RAM area built into the chip, which is the m...[Details]

The first one is a DMA mode of multiple channel acquisition void ADC_DMA_Config(void)  { ADC_InitTypeDef ADC_InitStructure; RCC_HSICmd(ENABLE); while (RCC_GetFlagStatus(RCC_FLAG_HSIRDY) == RESET);  ...[Details]

When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]

/*-----------------------------------------------     Name: Two-color dot matrix     Forum: www.doflye.net     Written by: shifang     Modification: None     Content: Using hc595 to drive two-color d...[Details]

Circuit: Using AT89S52 single chip microcomputer. P3.0 to P3.3 are connected to four external buttons. P3.4 to P3.7 are the bit selection ports for controlling the four digital tubes, and P1 is the s...[Details]

/*************************************************************************************       *   main.c:  the main file    *   NXP -- LPC1768   *   *      *   Author  :   light                      *...[Details]