442SA4X104BDN

In the past few days, the news that ZTE was "banned" by the US Department of Commerce has triggered widespread reflection and concern in various domestic industries about the lack of independent co...[Details]

For STM32, there are two ways to reset the software:   1) Use the official software library     The system reset function is directly provided in the stm32f10x_nvic.c file of the official software li...[Details]

1. Heart rate measurement principle 1. What is a heart rate module? The heart rate module is professionally used to monitor the heart rate of the wrist, fingers, forehead, earlobe, chest and other ...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

LiDAR: Autonomous driving from the perspective of optoelectronic technology LiDAR and competing sensor technologies (camera, radar, and ultrasonic) intensify the need for sensor fusion and the need...[Details]

ADI has established long-term good relationships with car manufacturers and Tier 1 component suppliers. Based on its previous long-term successful cooperation with new energy vehicles and suppliers a...[Details]

A crystal oscillator can be electrically equivalent to a two-terminal network consisting of a capacitor and a resistor in parallel and a capacitor in series. In electrical engineering, this network h...[Details]

//Environment: winavr+avr studio   char temp=0; ISR(TIMER1_COMPA_vect )//interrupt function {     // user code here     temp++;     if (temp==10)     temp=0;     PORTA=temp;     DDRA=0xff; } void ...[Details]

#include avr/io.h #include avr/interrupt.h int main() { DDRB|=0X20;//Set PWM waveform output, connected to port PB5, see the comment of OCR1A=15625 for details DDRE=0X04; PORTE=0X04; DDRA=0XFF; P...[Details]

#include "MSP430x44x.h"  void init_UART(void);  void uart_start(void);  void uart_send(void);  void uart_receive(void);  unsigned char RXDATA_BUF ,TXDATA_BUF ={0xbd,0x77,0x3d,0xc5,0xc6,0xf5,0x68,0x0d...[Details]

/**********（一）Timer A comparison mode*************/  int main( void )  {  WDTCTL=WDTPW+WDTHOLD; //Turn off watchdog  BCSCTL1 =CALBC1_1M Hz ; //Set DCO to 1MHZ  DCOCTL =CALBC1_1MHZ;    P1DIR |= BIT0; ...[Details]

;*********************************************************************** ; Self-receiving photoelectric detection.dt ;***************************************************************************  PORT...[Details]

Recently, the Ericsson Mobility Report pointed out that 5G is expected to be deployed first in dense urban areas to support eMBB (enhanced mobile broadband) services. The report predicts th...[Details]

This program has been in stable use for a long time. If we must trace its origin, it should be traced back to 1998. Since this system is based on IIC EEPROM, the reading and writing of 2401 is blocke...[Details]

Regulations and standards are yet to be improved, the public does not pay enough attention to security issues, enterprises strictly control production costs, and have relatively weak security awarene...[Details]