10,000 pieces on 7'' reel, 4000 pieces on 7'' reel and 500 pieces on prototype reel. Consult ATC for other options.
The above part number refers to a 600L Series (case size L) 10 pF capacitor, J tolerance (±5%), 200 WVDC, with T termination (Tin Plated over Nickel
Barrier, RoHS Compliant), Tape and Reel packaging.
ATC accepts orders for our parts using designations
with
or
without
the
“ATC” prefix. Both methods of defining the part number are equivalent,
i.e., part numbers referenced with the “ATC” prefix are interchangeable to
parts referenced without the “ATC” prefix. Customers are free to use either
in specifying or procuring parts from American Technical Ceramics.
For additional information and catalogs contact your ATC representative
or call direct at (+1-631) 622-4700.
Consult factory for 500 piece reels for prototyping.
Consult factory for additional performance data.
A M E R I C A N
ATC North America
sales@atceramics.com
T E C H N I C A L
ATC Europe
saleseur@atceramics.com
C E R A M I C S
ATC Asia
sales@atceramics-asia.com
2
w w w.a t c e ra m ic s .c om
ATC 600L Series Ultra-Low ESR, High Q, NPO RF & Microwave Capacitors
600L ESR vs. Frequency
1
ESR (Ohms)
0.1
27 pF
15 pF
8.2
3.3 pF
1.0 pF
(Typical)
0.01
100
1000
10000
Frequency (MHz)
600L Resonant Frequency Data
Frequency (GHz)
)
0.1
1.0
10.0
100.0
Capacitance (pF)
ATC 600L Series Data Sheet Test Condition Description
Capacitors mounted in series microstrip configuration on 10-mil thick Rogers RO4350
®
softboard,
22-mils wide 1/2 oz. Cu traces.
FSR
= lowest frequency at which S11 response, referenced at capacitor edge, crosses real axis on Smith Chart.
FPR
= lowest frequency at which there is a notch in S21 magnitude response.
A M E R I C A N
ATC North America
sales@atceramics.com
T E C H N I C A L
ATC Europe
saleseur@atceramics.com
C E R A M I C S
ATC Asia
sales@atceramics-asia.com
w w w.a t c e ra m ic s .c om
3
ATC 600L Series Ultra-Low ESR, High Q, NPO RF & Microwave Capacitors
Outline Dimensions
Y
W
L
T
L (0402)
L: .040 ± .004 (1.02 ± 0.1)
W: .020 ± .004 (.51 ± 0.1)
T: .024 max. (0.60 max.)
Y: .010 ± .006 (0.25 ± 0.15)
Inches (mm)
Suggested Mounting Pad Dimensions
W
L
Case Sizes L, S and F
Case Size
0402 (1005)
A Min.
.0275
(0.70)
.0393
(1.00)
.0590
(1.50)
B Min.
.0354
(0.90)
.0433
(1.10)
.0512
(1.30)
C Min.
.0157
(0.40)
.0236
(0.60)
.0236
(0.60)
D Min.
.0866
(2.20)
.110
(2.80)
.1259
(3.20)
Inches (mm)
T
B
B
0603 (1608)
0805 (2012)
A
C
D
Design Kits
Each Kit contains a selection of standard capacitor values for circuit prototyping.
Kit #
Kit
36T
Item #
DK0036T
Description
600L Series Ultra-low ESR,
High Q Microwave Capacitors
16 different values, 15 pcs. min. per value
Cap. Value
Range (pF)
0.1 to 2.0
Cap. Values
(pF)
0.1, 0.2, 0.3, 0.4, 0.5, 0.6, 0.7, 0.8, 0.9,
1.0, 1.1, 1.2, 1.5
1.6, 1.8, 2.0
1.0, 1.2, 1.5, 1.8, 2.0, 2.2, 2.4, 2.7, 3.0, 3.3
Tol.
(pF)
±0.1
Price
$90.00
±0.25
±0.1
Kit
37T
DK0037T
600L Series Ultra-low ESR,
High Q Microwave Capacitors
16 different values, 15 pcs. min. per value
6
1.0 to 10
3.9, 4.7, 5.6, 6.8, 8.2
10
±0.25
±5%
$90.00
Kit
38T
DK0038T
600L Series Ultra-low ESR,
High Q Microwave Capacitors
8 different values, 15 pcs. min. per values
10 to 27
10, 12, 15, 18, 20, 22, 24, 27
±5%
$50.00
For Online Kit Orders, Catalog & Application Notes,
Visit: www.atceramics.com
Sales of ATC products are subject to the terms and conditions contained in American Technical Ceramics Corp. Terms and Conditions of Sale
(ATC document #001-992 Rev. B 12/05). Copies of these terms and conditions will be provided upon request. They may also be viewed on ATC's website at www.atce-
ramics.com/productfinder/default.asp. Click on the link for Terms and Conditions of Sale.
ATC has made every effort to have this information as accurate as possible. However, no responsibility is assumed by ATC for its use, nor for any infringements of rights of
third parties which may result from its use. ATC reserves the right to revise the content or modify its product without prior notice.
Hotswap design, I have always understood it literally as hot plug, just like the USB interface, it can be directly plugged in and used without restarting to identify, so it is much more convenient. I ...
In the MCU market, except for the low-end 8-bit market where we can see Sunplus ranked 8th and Winbond ranked 10th, there are few signs of Chinese chips. In sharp contrast, MediaTek and Spreadtrum dom...
MOS tube burns out during discharge of battery protection board MOS burns out: There is a short circuit during welding, the MOS tube is not fully opened during discharge, and is in a closed or half-op...
[b]1. Resistor series circuit[/b][align=left][color=rgb(34, 34, 34)][font="]The figure below shows a resistor series circuit. There are no other components, so it is called a pure resistor circuit.[/f...
Brand new original TI stellaris Launchpad LM4F120 development board, hope to exchange for 4000 core coins [size=4][color=#ff0000][b] has been bought by exiao for 4000 core coins! [/b][/color][/size] [...
The most significant feature of IPS panels is that both electrodes are located on the same surface, unlike other LCD panels, which have electrodes arranged on top and bottom surfaces in a three-dim...[Details]
introduction
The concept of the smart home is gradually developing and gaining market acceptance. We believe its ultimate form lies in the interconnection of all home appliances through open i...[Details]
Electric vehicles are now widespread, but they've brought with them a host of problems, the most prominent of which is charging. Small electric vehicles (EVs) are a new form of transportation in a ...[Details]
Keysight Technologies is combining its electromagnetic simulator with Synopsys' AI-driven RF design migration flow to create an integrated design flow for migrating from TSMC's N6RF+ process techno...[Details]
Reflow soldering is one of the most commonly used methods in electronics manufacturing, allowing for the soldering of large numbers of components in a relatively short time. However, any experience...[Details]
Plessey Semiconductors has been acquired by Haylo Labs, which was established in March last year with a $100 million, five-year loan from Chinese technology company Goertek.
Haylo Labs w...[Details]
In the field of intelligent driving, regulations are becoming increasingly stringent, and the technical threshold continues to rise. Especially after the traffic accident in March 2025, the Ministr...[Details]
In daily life, when we purchase a transformer, we are faced with the installation and wiring procedures. Generally speaking, large transformers such as power transformers are equipped with speciali...[Details]
Methods of DC motor speed regulation:
1. The voltage regulator can be used to change the input voltage and speed directly, which is often used for large kilowatt-level motors.
2. Thyristo...[Details]
Introduction: In digital circuit calculations, there is no concept of decimal points. You know where the decimal is, but the circuit does not know where the decimal point is. Therefore, you need to...[Details]
"I want to ask why there are so many manufacturers making mobile phone CPUs, but only Intel and AMD make computer CPUs?"
The progress of domestic PC CPU production has disappointed many ...[Details]
In camera and display systems, the demand for high-performance and low-power data interfaces is driving continuous technological evolution. The evolution of MIPI D-PHY and MIPI C-PHY clearly ...[Details]
Hair dryer structure and working principle: It is mainly used for drying and shaping hair, but it can also be used for local drying, heating and treatment in laboratories, physiotherapy rooms, ind...[Details]
With the improvement of China's supporting infrastructure and the accumulation of technology and capital, demand for industrial automation and intelligent applications of machine vision technology ...[Details]
Using the STM32F103 as a microprocessor, a low-cost wireless WiFi music player system was designed. This system, combined with the WM-G-MR-08 (wm631) module for WiFi data reception and the VS1003B ...[Details]