(1) It is best to place components on one side. If you need to place components on both sides, place pin-type components on the bottom layer (BottomLayer). It is best to place components on one side. ...
It is a mature architecture in the company. I don't know what happened to it. The board ID in eeprom is correct, which should indicate that there is no problem from PCI to 9054. But the connection fro...
I have now made two base station (coordinator) boards, two terminal boards, two base stations (respectively marked as base station 1 and base station 2) with the same program, and two terminals (respe...
RM0008 Rev11 Page 843:Bit 16 for OUT endpoint 0, bit 18 for OUT endpoint 3Is itBit 16 for OUT endpoint 0Bit 17 for OUT endpoint 1Bit 18 for OUT endpoint 2 ???How to understand it???0008.jpg
(32.17 KB)...
Is it possible to carry out secondary development of EDA software and use the software to perform the following operations one by one: "Modify device parameters---〉perform simulation---〉record results...