Hey guys, my T1CNT can't count automatically in CCS environment, but my enable bits have been set. The program of initial event manager is as follows:void init_EV(void){EvaRegs.T1CNT=0; // The initial...
IntroductionThe quartz accelerometer is a high-precision acceleration sensor with a higher range and stability than MEM. It can be combined with various gyroscope systems to achieve high-precision att...
[i=s]This post was last edited by dontium on 2015-1-23 11:33[/i] Noise is defined as any unwanted signal in an electronic system. Noise includes inherent noise and external noise. The spice simulation...
I am working on a project recently, combining two existing devices. The two devices' CPUs need to communicate, and all interfaces have other uses, leaving only one Jtag. Is there any way to use Jtag f...
Section 1: Mood and Clock To be honest, I don't have many microcontrollers that I can use. I always think that any microcontroller can develop a good product. In the past few years, I used 51 and alwa...
When the 430 microcontroller enters LPM3 mode at a baud rate of 9600, it can only wake up after receiving 10 bytes. How can I make it wake up after receiving 1 byte?...