QM42VN6D

Entering the information age after the millennium, the huge demand for semiconductor chips has made China the world's largest semiconductor market. According to relevant data, the scale of my count...[Details]

On April 20, Alibaba Group announced that it would acquire the chip company Zhongtian Microelectronics and invest in six chip companies. Yesterday, JD.com CEO Liu Qiangdong said in a...[Details]

Recently, the results of the 2018 German Red Dot Design Award were announced. GoodWe, a company located in Suzhou High-tech Zone, stood out among thousands of outstanding design products from 5...[Details]

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

A few days ago, Hanergy Chairman Li held a grand launch of Hanwa new products, which once again attracted the attention of the mass media to the development of photovoltaics. The unique Hanergy has gr...[Details]

In the Huaxing Optoelectronics LCD panel factory located in Guangming New District, Shenzhen , apart from a few people repairing machines, it is often difficult to see other people. Here, ev...[Details]

This program is used in the development board to generate sounds of different frequencies. The overall program is relatively simple, mainly using two timers. The code and my comments are as follows. ...[Details]

On the eve of 5G commercialization, ZTE has established and adhered to the 5G pioneer strategy, focusing on 5G end-to-end solutions, and investing in standard setting, ...[Details]

1. Function and purpose         There are two pins BOOT0 and BOOT1 on each STM32 chip. The level status of these two pins when the chip is reset determines which area the program starts from after th...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

#include reg52.h #define PORTLEN P0 sbit bit_select = P2^0; sbit seg_select = P2^1; unsigned char src = {0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f ,0x6f,0x77,0x7c,0x39,0x5e,0x79,0x71}; unsigne...[Details]

#include reg52.h //Include the header file. Generally, no modification is required. The header file contains the definition of special function registers.                              /*-------------...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

#include  #include     #include "lcd12864.h"  #define uint unsigned int #define uchar unsigned char #define MISO PINB.6 #define SCK PORTB.7 #define MOSI PORTB.5 #define CSN PORTC.0 #define CE PORTC.1...[Details]

#include iom16v.h   #include macros.h #include "key.h" #include "1602.h" #include "delay.h" unsigned char display ={0,0,0}; //display data void main(void) {  unsigned char Key;    LCD_init();  ...[Details]