-
Emergency hand-held lamps powered by 6V maintenance-free batteries are widely used in rural areas. The charger used is a transformer step-down and single diode half-wave rectifier, and the charging...[Details]
-
As cellular phones become more advanced, the power consumption of the system during operation and the power consumption during standby are also increasing. Therefore, the power management design of...[Details]
-
1. Introduction to CIF Board
Fieldbus integration based on PC system
Whether it is a master or a slave, fieldbus has won unanimous praise in the field of PC-based automation. For more...[Details]
-
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
-
Portable power applications are broad and varied. Products range from wireless sensor nodes with average power consumption of only a few microwatts to in-vehicle medical or data acquisition systems...[Details]
-
With the popularity of digital appliances, rechargeable batteries can be seen everywhere in people's daily lives and have become one of the indispensable daily necessities.
This article gives ...[Details]
-
0 Introduction
PROFIBUS is an open digital communication system with a wide range of applications, which has been included in the international standards IEC 61158 and IEC 61784. Since the gen...[Details]
-
0 Introduction
In microwave, radar, radio and television, and communication systems, the problem of coupling RF power is often encountered. A directional coupler is a directional power divide...[Details]
-
During the operation of electronic equipment,
memory
failure or failure will not only lead to economic losses, but also may lead to catastrophic consequences. Therefore, memory testing has ...[Details]
-
When programming in C and assembly, there are interface issues between variables and functions in C and assembly.
Variables defined in a C program are put into the .bss area after being compile...[Details]
-
After the development of the single-chip microcomputer application system is completed, the system often freezes at the work site due to noise interference, electromagnetic interference, overvoltag...[Details]
-
In the process of designing electronic products, we usually control the cost of the designed products, always try to simplify the circuit, reduce the components, and simplify the installation process....[Details]
-
Abstract Based on the overview of the hardware design of digital synthesis sweeper, this paper describes a USB2.0 interface design based on ISP1362, including the hardware structure design of USB i...[Details]
-
0 Introduction
A wireless sensor network is a type of RGS system (remote ground sensor system). It is a detection system that uses a variety of sensors as comprehensive intelligence collection...[Details]
-
1 Power Module Design
The power supply in this study is directly connected to the neutral and live wires, and converted through the lnk306 chip. The 13V voltage required by the control mod...[Details]
Programming Basics
京公网安备 11010802033920号
EEWORLD
