STM32f407 uses a MAC controller. Under this controller, do the frames I receive and send include IP headers and TCP headers, or do the MAC controllers already handle these two headers? The information...
I use a baud rate of 57600 to receive data information from two CPUs, and use the computer serial port to monitor the data.I found a problem:when the computer is turned on, the serial port (DMA recept...
[i=s]This post was last edited by nnnf on 2019-10-14 16:52[/i]As the title says, I want to use xpctarget to control maxon motor through NI6289 board. The motor is equipped with epos2 driver. xpcTarget...
Can anyone explain how to use the ADC10 of G2553 and its built-in ADC10DTC, including how to get the value (e.g., repeat single-channel mode)? It would be best if there is an example. Thank you......