STM32L021G4P7DTR

In the past few days, the news that ZTE was "banned" by the US Department of Commerce has triggered widespread reflection and concern in various domestic industries about the lack of independent co...[Details]

Using Systick timer to achieve delay 1. SysTick timer characteristics The SysTick timer is a 24-bit down counter, that is, when vlue is decremented to 0, an interrupt is triggered and the load va...[Details]

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

Since the first draft of the 5G NR standard was officially launched at the end of 2017 , the 5G commercialization process has taken a substantial step forward. From that moment on, mo...[Details]

When Amazon quietly launched a product called Elastic Computing Cloud 12 years ago, the Internet industry in China, across the ocean, also ushered in an unprecedented development opportunity. Let's...[Details]

On May 16, in response to the public opinion storm caused by Lenovo's " 5G voting" incident, Lenovo Holdings Chairman and Lenovo Group Founder Liu Chuanzhi, Lenovo Gr...[Details]

1. Heart rate measurement principle 1. What is a heart rate module? The heart rate module is professionally used to monitor the heart rate of the wrist, fingers, forehead, earlobe, chest and other ...[Details]

According to MEMS Consulting, single-chip radar system-on-chip (SoC) is becoming one of the most popular new sensors . Its widespread adoption in automobiles has greatly increased sales, thereby pr...[Details]

If you do not use an external crystal on the STM32, the connection method of OSC_IN and OSC_OUT If you use the internal RC oscillator instead of an external crystal, please follow the following metho...[Details]

STM32F103 has dual DAC channels, using DMA to achieve 2 waveform outputs #include "stm32f10x.h"      //DAC1,2 initialization   void dac_init(void)   {       RCC- APB2ENR |= RCC_APB2ENR_IOPAEN; //Tu...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

Design a second and minute pulse generator for a single-chip microcomputer using the interrupt method. Assume that P1.0 generates a positive pulse of one machine cycle per second, and P1.1 generates ...[Details]

#include avr/io.h #include avr/interrupt.h int main() { DDRB|=0X20;//Set PWM waveform output, connected to port PB5, see the comment of OCR1A=15625 for details DDRE=0X04; PORTE=0X04; DDRA=0XFF; P...[Details]

#include avr/io.h          #include util/delay.h #include avr/interrupt.h //Interrupt function header file //Function declaration void Port_Init(void); //Port initialization configuration void Comp...[Details]