FlashPro4 Device Programmer
Quickstart Card
This quickstart card applies only to the FlashPro4 device programmer.
Kit Contents
Quantity
1
1
1
USB A to mini-B USB cable
FlashPro4 10-pin ribbon cable
Description
FlashPro4 programmer standalone unit
Software Installation
If you are already using Actel's Libero® Integrated Design Environment (IDE), you have the
FlashPro software installed as part of Libero IDE. If you are using the FlashPro4 device
programmer for standalone programming or on a dedicated machine, download and install the latest
release of the FlashPro software from the Actel website. The installation will guide you through the
setup. Complete the software installation before connecting the FlashPro4 device programmer to
your PC.
Note:
Libero IDE v8.6 SP1 or FlashPro v8.6 SP1 are the minimum versions required to run
FlashPro4.
Software releases:
www.actel.com/download/program_debug/flashpro.
Hardware Installation
After installing the software successfully, connect one end of the USB cable to the FlashPro4 device
programmer and the other end to your PC USB port. The Found Hardware Wizard will open twice.
Use the wizard to install the driver automatically (recommended). If the Found Hardware Wizard
cannot find the drivers automatically, then ensure you have properly installed the FlashPro software
prior to installing the hardware. If the drivers still cannot be installed automatically, then install
them from a list or specific location (advanced).
© 2009 Actel Corporation. All rights reserved.
FlashPro4 Device Programmer Quickstart Card
If FlashPro was installed as part of the Libero IDE default installation, the drivers are located at
C:/Libero/Designer/Drivers/Manual.
For a standalone FlashPro default installation, the drivers are
located at
C:/Actel/FlashPro/Drivers/Manual.
Actel recommends the automatic driver installation.
Common Issues
If the On LED does not light up after FlashPro4 driver installation, the driver might not be installed
correctly and you must troubleshoot the installation. For more information, refer to the
FlashPro
Software and Hardware Installation Guide
and the “Known Issues and Workarounds” section of the
FlashPro software release notes:
www.actel.com/download/program_debug/flashpro.
Documentation Resources
For further FlashPro software and FlashPro4 device programmer information, including user's
guide, installation guide, tutorial, and application notes, refer to the FlashPro software page:
www.actel.com/products/hardware/program_debug/flashpro.
Technical Support and Contacts
Technical support is available online at
www.actel.com/support,
by email at tech@actel.com, or by
phone:
Phone (NA): 800.262.1060
Phone (Int'l): +1 650.318.4460
Actel Sales offices, including Representatives and Distributors, are located worldwide. To find your
local representative go to:
www.actel.com/company/contact.
50200198-0/11.09
京公网安备 11010802033920号
EEWORLD
