EEWORLDEEWORLDEEWORLD

Part Number

Search

M2019S2A2G30-RO

Description
Toggle switch spdt ON-off-(ON)
CategoryTopical application    Mechanical and electrical/engineering/automation   
File Size1000KB,10 Pages
ManufacturerNKK
Websitehttps://www.nkkswitches.com.cn
Environmental Compliance
Download Datasheet Parametric View All

M2019S2A2G30-RO Overview

Toggle switch spdt ON-off-(ON)

M2019S2A2G30-RO Parametric

Parameter NameAttribute value
MakerNKK
Product CategoryToggle Switches
RoHSyes
Contact formSPDT
switch functionON - OFF - (ON)
Contact current rating0.4 Volt-Amp at 28 Volts
Termination typeSolder Terminals
Installation styleThrough Hole
Terminal sealEpoxy
Contact platingGold
ActuatorB
Series M
A
Miniature Toggles
General
Specifications
Electrical Capacity (Resistive Load)
Power Level (silver):
6A @ 125V AC & 3A @ 250V AC
4A @ 30V DC for On-None-On & On-None-Off; 3A @ 30V DC for all other circuits
Logic Level (gold):
0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Logic/Power Level (gold over silver):
Combines silver & gold ratings
Note: Find additional explanation of dual rating & operating range in Supplement section.
Contact Resistance:
10 milliohms maximum for silver; 20 milliohms maximum for gold
Insulation Resistance:
1,000 megohms minimum @ 500V DC
Dielectric Strength:
1,000V AC minimum between contacts for 1 minute minimum;
1,500V AC minimum between contacts and case for 1 minute minimum
Mechanical Life:
100,000 operations minimum; 50,000 operations minimum for flat, locking & splashproof devices
Electrical Life:
25,000 operations minimum for silver; 50,000 operations minimum for gold;
50,000 operations minimum for silver at 3A @ 125V AC
Angle of Throw:
25°
Toggle:
Bushing:
Case:
Movable Contactor:
Movable Contacts:
Stationary Contacts:
Brass with chrome plating
Frame:
Stainless steel
Brass with nickel plating
Support Bracket:
Brass with tin plating
Diallyl phthalate resin (UL94V–0)
Phosphor bronze with silver or gold plating
Silver alloy (code W); copper with gold plating (code G); or silver alloy with gold plating (code A)
Silver with silver plating (code W); copper or brass with gold plating (code G);
or silver with gold plating (code A)
Terminals:
Copper or brass with silver plating; or copper or brass with gold plating
Pushbuttons
Rockers
Toggles
Other Ratings
Programmable Illuminated PB
Materials & Finishes
Rotaries
Keylocks
Slides
Environmental Data
Operating Temp Range:
–30°C through +85°C (–22°F through +185°F)
Humidity:
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
Vibration:
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
Shock:
50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Sealing:
Splashproof bushing options B3, D3, D8, L3, & L8, which have o-rings inside & outside the
bushing, meet IP67 of IEC60529 Standards.
Mounting Torque:
3.0Nm (26.55 lb
in) double nut for large bushing;
1.5Nm (13 lb
in) double nut & 0.7Nm (6 lb
in) single nut for all other bushings
Soldering:
Wave Soldering (PC version) for Gold: See Profile A in Supplement section.
Manual Soldering for Gold: See Profile A in Supplement section.
Wave Soldering (PC version) for Silver: See Profile B in Supplement section.
Manual Soldering for Silver: See Profile B in Supplement section.
Note: Lever must be in OFF (center) position while soldering.
Cleaning:
These devices are not process sealed. Hand clean locally using alcohol based solution.
Tactiles
Installation
Tilt
Processing
Touch
Indicators
Standards & Certifications
Supplement
Flammability Standards:
UL94V–0 for case
UL:
File No. E44145
All models recognized at 6A @ 125V AC, 3A @ 250V AC or 0.4VA maximum @ 28V DC maximum.
Add “/U” to end of part number to order UL mark on switch.
Add “/CUL” to end of part number to order cULus mark on switch.
CSA:
File No. 023535_0_000
All models recognized at 6A @ 125V AC or 3A @ 250V AC or 0.4VA maximum @ 28V maximum.
Add “/C” to end of part number to order CSA mark on switch.
Accessories
A48
www.nkk.com
Frequency tracking part of wireless power transmission
[size=16px]The schematic diagram is shown in the figure. S1 and S4 are a group of square waves with the same waveform, and S2 and S3 are another group of square waves with the same waveform. These two...
平漂流 Electronics Design Contest
1 hour introduction to C language[1]
1. I believe that many friends who love electronics should be familiar with the term single-chip microcomputer. However, some friends may only hear that it is called a single-chip microcomputer, and m...
tonytong MCU
[Perf-V Evaluation] Development of Hummingbird Timer Interrupt Based on Perf-V Development Board
Pengfeng Technology provides the Hummingbird E203 soft core for the Perf-V development board. Developers can easily use the RISC-V instruction set for programming applications. This article will try t...
superstar_gu FPGA/CPLD
What is the difference between product-term based PLD design and lookup table based PLD design?
What is the difference between product-term based PLD design and lookup table based PLD design?...
victor556 Embedded System
485 Communication abnormality
I recently encountered a problem with 485 communication. I need help from all the experts. The situation is as follows: I use a Kunlun touch screen to read a 24V powered, 485 output temperature and hu...
HT001 MCU
Domestic DCDC
What is the quality of domestically produced DCDC now?...
hinii23 Power technology

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 307  1540  1771  856  743  7  32  36  18  15 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号