EEWORLDEEWORLDEEWORLD

Part Number

Search

PH1-PLPLA2562

Description
Transponder, 10709Mbps(Tx), 10709Mbps(Rx), LC/SPC Connector,
CategoryWireless rf/communication    Optical fiber   
File Size240KB,6 Pages
ManufacturerLumentum Operations LLC
Download Datasheet Parametric View All

PH1-PLPLA2562 Overview

Transponder, 10709Mbps(Tx), 10709Mbps(Rx), LC/SPC Connector,

PH1-PLPLA2562 Parametric

Parameter NameAttribute value
Objectid4000962913
Reach Compliance Codecompliant
Other featuresIT ALSO OPERATE FROM 1280NM TO 1600NM
body width56.1 mm
body height13.2 mm
Body length or diameter76.5 mm
Connection TypeLC/SPC CONNECTOR
Data rate (receive)10709 Mbps
Data rate (send)10709 Mbps
Emitter/Detector TypePIN PHOTODIODE
Fiber optic equipment typesTRANSCEIVER, TRANSPONDER
Nominal operating wavelength1528 nm
Nominal optical power output1.584 mW
minimum return loss-27 dB
Sensitivity-17 dBm
COMMUNICATIONS MODULES & SUBSYSTEMS
10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder
PH1 Series
Key Features
• Three configurations supporting SR2/IR2/LR2 applications
• Supports dense wavelength division multiplexing
(DWDM) applications (without wavelocker)
• Microprocessor controls to support I2C
• Integrated 16:1/1:16 mux/demux
• Small form factor package (2.2" x 3.0" x 0.53") for high
density applications
• Low power consumption: 4.8 W typical, 6.8 W maximum
for TDM applications
• 70 °C maximum operating temperature
• High sensitivity PIN or APD receivers
• SONET, FEC, Ethernet and Multirate Capable Versions
• Forward, counter and line timing clocking modes
Applications
Telecommunications
Metropolitan Area Networks
Subscriber loop
Intra-office SONET/SDH
High bit-rate data communications
JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system
applications with reaches of up to 80 km. The series includes three different
transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM
applications. Each transponder accepts 16 bits of parallel digital data and converts
it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ
modulated optical signal and converts it into 16 bit wide parallel digital data.
The PH1 series offers low DC power dissipation and is available in either a small
form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53
inches) package, depending on system thermal performance requirements. The
transmit design uses an Electro-Absorptive Modulated Laser (EML) which,
depending on the configuration, produces an average output power of between
-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm
typical sensitivity) receiver is available, based on system configurations.
JDSU PH1 Series transponders are designed to support the following data rates:
9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),
10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.
Compliance
• Telcordia GR-253-Core
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
Domestic FPGA Gaoyun GW1N-4 series development board evaluation - unboxing + hardware part 2
[i=s]This post was last edited by Breaking Tradition on 2021-12-12 12:52[/i]I have been waiting for several days. The express was sent on the 6th and arrived yesterday afternoon. I didn’t have time to...
打破传统 Domestic Chip Exchange
How to simulate a counter with the same frequency as the main clock?
Solution:process (CLK) -- This method can be used to simulate a counter with the same frequency as the main clockbeginif (falling_edge(CLK)) thenSIGNAL_CLK_CNT(3 downto 1)end if;end process;SIGNAL_CLK...
eeleader FPGA/CPLD
Can the disk use a large number of micro disks to form an internal raid0 to improve the read and write performance?
Simply increasing the disk speed to improve read/write performance is not ideal, and the disk is prone to breakage and flying out if it rotates too fast, which may cause casualties. If micro disks are...
1200324 Embedded System
This is a very strange request, is it possible?
I have a very strange requirement - an STM32 external ferroelectric memory. The requirements are: preferably an SPI interface; preferably a 64Kb capacity; more than millions of erase and write times; ...
猫熊 Integrated technical exchanges
NXP introduces new plastic packaged RF power transistor
Cost-effective solutions for all RF applications Shanghai , China , June 3 , 2011 - NXP Semiconductors NV (NASDAQ: NXPI) today launched a full range of overmolded plastic (OMP) RF power devices with p...
恩智浦半导体 RF/Wirelessly
EEWORLD University ----TI High Precision Laboratory - Current Feedback Amplifier
TI Precision Labs - Current Feedback Op Amp : https://training.eeworld.com.cn/course/4107...
hi5 Talking

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 672  2597  1497  1862  1006  14  53  31  38  21 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号