ECS-120-20-33Q-CGP-TR

introduction 1 The significance of using RTOS on MSP430 It is understandable that it is meaningless to use RTOS on MSP430. Because the hardware resources of MSP430 are limited (for exampl...[Details]

Microchip's PIC18F46J50 is a low-power, high-performance 8-bit USB microcontroller (MCU) using nanoWatt XLP technology. The current in deep sleep mode can be as low as 13nA, the operating voltage i...[Details]

Google's driverless technology is not only an eye-catching technology, but also a subversion of the car usage model. Those who have watched anti-terrorism films and TV dramas must have been im...[Details]

The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]

1 About IRS2530D and PIC12F629 1) Introduction to IRS2530D IRS2530D adopts 8-pin DIP or 8-pin SOIC package. The pin diagram of IRS2530D ...[Details]

Two simple circuits are implemented to drive two LEDs from a battery powered microprocessor. This design is based on a circuit that uses three resistors and a microprocessor I/O pin as an input h...[Details]

1 Introduction Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]

Microcalorimetry is used to determine energy relationships. Microcalorimetry techniques are often required when performing calorimetric experiments with small sample sizes or slow heating rat...[Details]

A standard cell is an electrochemical cell used as a voltage reference standard in many electrical standards laboratories . If properly maintained, standard cells are very stable. The ...[Details]

Overview As a remote network communication control method with advanced technology, high reliability, complete functions and reasonable cost, CAN-bus has been widely used in various automa...[Details]

Every time I go home and walk up the stairs, I am always scared. The corridor lights are often broken, and no one changes the bulbs, or they are not smart enough and need to be operated manually. E...[Details]

a. Keep the battery clean, wipe off the spilled electrolyte, contaminated dirt and dust in time; keep the poles and terminal clamps clean and in good contact, and apply vaseline or butter to preven...[Details]

The capacity of a battery depends on the amount of charge and discharge, in addition to some factors of the battery itself. Obviously, if the charge and discharge of the battery can be recorded all...[Details]

The principles to be followed are as follows: (1) In terms of component layout, related components should be placed as close as possible. For example, clock generators, crystal oscillat...[Details]

Designing low power circuits while achieving acceptable performance is a difficult task. Doing so in the RF bands increases the challenge dramatically. Today, nearly everything has wireless...[Details]