CCN-7800LF-07-3650-F-G

Chip: STM32F107VCT6 Application Pin: THOUSANDS, RMII STM32CubeMX is very convenient to use ETH. The software comes with LWIP and configuration. This time, STM32F107VCT6+DP83848CVV is used. The MII a...[Details]

Remarks: Focus on IoT application development and share IoT technology experience. Software platform: IAR6.5 TCP/IP protocol stack: LWIP1.4.1 Hardware platform: STM32F103C8T6 wired communication ...[Details]

introduction In the general project development process, two or more microcontrollers are often required to communicate to complete data transmission. For example, a quadcopter wirelessly transmits d...[Details]

Security PPP is a new model of urban video surveillance projects: 1) The government and social capital establish a project company in a certain proportion; 2) The project company participates in the ...[Details]

Overview Lightning is a strong discharge phenomenon that occurs between thunderstorm clouds and between thunderstorm clouds and the earth due to severe convective weather. Lightning is gen...[Details]

Artificial intelligence There is no inherent bias in AI. It does not "think" something is true or false for reasons that cannot be explained by logic. Unfortunately, human bias exists in mach...[Details]

This program uses the eight-channel ADC single acquisition mode. According to the configuration, ADC12SC will automatically reset after the conversion is completed in the single mode, so it is necess...[Details]

sprintf is a function in the C language library that converts data types. There is a situation where In 51 MCU, define unsigned char temp; Then I want to use the serial port to print out temp in deci...[Details]

Ouster LiDAR OS-1 (left) and OS-2 (center) Velodyne invented the modern 3D LiDAR scanner in the mid-2000s, but in recent years conventional wisdom has held that Velodyne’s design — 64 lasers mounted...[Details]

1. Common knowledge about DMA.  1. Function: to achieve high-speed data transmission between chips. That is, it can achieve data transmission without occupying the CPU.  2. Mode: There are three tran...[Details]

Table of contents: 1 Overview 2: Common interrupt functions 3: PWM output  1 Overview In development, timers are widely used, which can be simply summarized into three aspects: 1.1: Application of ...[Details]

6MHz crystal oscillator, using timer counter 1, using interrupt mode, through P1.0 to make a light emitting diode turn on for 100ms, turn off for 300ms, and repeat. Assembly programming is used to ac...[Details]

Title: Use two dynamic digital tubes to display from 0 to 60, output from the P1 port of 89C51, without adding a decoder, and directly connect the digital tubes. Note that they are dynamic digital tu...[Details]

#include "MSP430x22x4.h"   #define uchar unsigned char  #define uint  unsigned int  #define comm  0  #define dat   1  #define sclk_1 P4OUT|=0x01 //sclk=1; 001----p4.0  #define sclk_0 P4OUT&=0x06 //sc...[Details]

5.1. Usage of EM78 series 8-bit microcontroller special instructions 5.1.1. Table Lookup Instructions and Usage The EM78 series 8-bit microcontroller uses three steps to look up the table: (1) "call"...[Details]