This is one way, the other way is the same, I carved a board myself, soldered half of it, and found it too messy. I don't know who used software to make a standard PCB...
The module does not support MMS protocol, so I have to write it myself. Has anyone done anything like this? Please give me some advice. My requirement is very simple, just send a picture. Can anyone h...
I recently used VM8 to install Ubuntu 12.10 for fun, and encountered many problems along the way. After the installation, the system defaulted to NAT connection mode, and I could surf the Internet dir...
Hello everyone: When I used keil to compile a project, an error occurred: Error: C3065E: Type of input file 'ftl' unknown. Error: C3079E: armcc command with no effect. I found some online articles say...
I don't know the touch IC model. The six spring-loaded buttons are connected to the touch IC, which has only one port connected to the microcontroller. When no button is pressed, the touch IC always s...
China Energy Storage Network News:
On April 24, State Grid Corporation of China (hereinafter referred to as "SGCC") and China Southern Power Grid Co., Ltd. (hereinafter referred to as "CSGC")...[Details]
When
artificial intelligence
can help humans take on some work, we always divide the responsibilities of both parties very clearly. When humans work, we rarely see
artificial intelligen...[Details]
"Originally, there are many people who can design very good
chips
, but the market does not give domestic
chips
the opportunity to iterate, and domestic companies cannot give engine...[Details]
1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows: The output is as follows: It can...[Details]
CMSIS Driver has similar API functions and similar calling methods. It is a further encapsulation based on the ST HAL library. It is much more convenient and simpler to use and configure than the ST ...[Details]
Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode. Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows: ...[Details]
introduction STM32 has many registers, which are difficult to remember, so the official packaged two sets of library functions. One is the standard library, but the official has not updated it on F7,...[Details]
Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]
Artificial Intelligence (AI) is undoubtedly the hottest topic in the technology industry in the past one or two years. In addition to the huge investments made by technology giants, financial and o...[Details]
This small program is still the use of timer, which is relatively simple. The specific parts are noted in the comments, please refer to the comments. /*********************************************...[Details]
This is also a routine in the development board, with explanations of the key points. The program is as follows: /********************************************************* Program notes: First...[Details]
What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]
With the large-scale development of the domestic household photovoltaic market and the improvement of component and inverter technology, the system cost has dropped significantly in the past year. The...[Details]
In order to strengthen the traceability management of recycling and utilization of power batteries for new energy vehicles, and to standardize and guide all relevant parties to fulfill their tracea...[Details]