Capacitance Change with Reference to +25°C and 0 VDC Applied (TCC)
Aging Rate (Maximum % Cap Loss/Decade Hour)
Dielectric Withstanding Voltage
Dissipation Factor (DF) Maximum Limits @ 25ºC
Insulation Resistance (IR) Limit @ 25°C
-55°C to +125°C
±15%
3.0%
250% of rated voltage
(5 ±1 second and charge/discharge not exceeding 50 mA)
See Dissipation Factor (DF) Limits Table
See Insulation Resistance Limit Table
(Rated voltage applied for 120 ±5 seconds @ 25°C)
Parameters/Characteristics
Regarding aging rate: Capacitance measurements (including tolerance) are indexed to a referee time of 48 or 1,000 hours. Please refer to a part number specific
datasheet for referee time details.
To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.
Capacitance and dissipation factor (DF) measured under the following conditions:
1 kHz ±50 Hz and 1.0 ±0.2 Vrms if capacitance ≤ 10 µF
120 Hz ±10 Hz and 0.5 ±0.1 Vrms if capacitance > 10 µF
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as
Automatic Level Control (ALC). The ALC feature should be switched to "ON."
[i=s]This post was last edited by snoweaglemcu on 2017-12-16 21:52[/i] [align=left] Thanks to EEworld for its support and soso for her care. I am very happy to get a CC3220 LaunchPad board and share w...
This recommendation is for social recruitment, requiring a bachelor's degree in computer/communication/electronics related majors with more than one year of work experience; software (C/C++/JAVA)/soft...
[i=s]This post was last edited by jennyzhaojie on 2021-3-20 17:58[/i]Lighting quality is an important indicator in the evaluation of home environment. However, it is obviously lacking in data support ...
There are many development environments for STM32. The official manual also provides three types: IAR Embedded Workbench, MDK-ARM and TrueSTUDIO. Today I tried CooCox CoIDE, which is a free integrated...
I created a new PCI driver (the PCI device is good and the device number was written when it was created). After installation, there is an exclamation mark on the device name in the device manager. Wh...