When debugging ADX, it jumps to a lot of DCI instructions. The ADS settings are according to the chip manual, which should be correct. Please help me....
In the embedded ARM9 platform, LINUX system, can the dual-port RAM driver realize its configuration initialization? That is, the bus cycle, data bit number, ARM bank occupied and other configuration i...
I just received a call from an anonymous person, asking me to pick up a package at the door. After I got it, I looked at the Jun Yixing box and felt a little confused: I didn’t seem to buy anything. A...
There are two pictures in the attachment, which are displayed in static and scanning mode respectively.
For static display, 9 74HC595 chips are used. This method does not have high requirements on it ...
I just started Linux embedded development, and my boss asked me to do the PCI to IDE hard disk storage conversion, but I can't find it online. Does anyone have any advice? Suggestions are also welcome...
Event: The company simultaneously released its 2017 annual report and the first quarter report of 2018. In 2017, the company achieved revenue of 8.886 billion yuan, a year-on-year increase of 48.01...[Details]
0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]
On May 8,
Google
I/O 2018 Developer Conference was held as scheduled in Mountain View, California. In the second year of the full promotion of the "AI first" strategy, artificial intelligen...[Details]
Household photovoltaic power stations mainly utilize idle resources on existing household buildings, such as roofs, wall facades, balconies, courtyards, etc., to install and use distributed photovo...[Details]
The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]
The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]
MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]
Assume that the MCS-51 microcontroller uses a 12MHz crystal oscillator, and wants to use a timer to generate a pulse with a duty cycle of about 30% and a period of 60ms at port P1.0. ;==============...[Details]
Unfortunately, my serial port has some problems and I can't print information. I can only debug to view variables and see the values. Fortunately, there is not much AD conversion code, and I can use ...[Details]
The following comes from - "cortex-M3 Definitive Guide" Special function register group: Program Status Registers (PSRs or xPSRs) Interrupt mask register group (PRIMASK, FAULTMASK, and BASEPRI) ...[Details]
Pay attention to whether the new lock matches the old door Smart locks have many advantages over traditional mechanical locks. Although the domestic penetration rate is not high, with the strength...[Details]
With the development of electronic devices, more and more people pay attention to flexible electronic devices, which refer to electronic devices that can still work under certain deformation condit...[Details]
China has become the world's largest demander of
industrial robots
, with a stable market development. Automobile and parts manufacturing are still the main application areas of industrial
...[Details]