within 5°C of the specified classification temperature (T
C
)
Ramp-down rate (T
p
to T
smax
)
Time 25°C to peak temperature
Reflow cycles
*Tolerance
for peak profile temperature (T
P
) is defined as a supplier minimum and a user maximum.
Sn-Pb Eutectic
Assembly
100°C
150°C
60 - 120 sec.
3°C/sec. max
183°C
60 - 150 sec.
see Table 1
20 sec.
6°C/sec. max
6 min. max
2 max
Pb-Free
Assembly
150°C
200°C
60 - 120 sec.
3°C/sec. max
217°C
60 - 150 sec.
see Table 2
30 sec.
6°C/sec. max
8 min. max
2 max
**Tolerance
for time at peak profile temperature (t
p
) is defined as supplier minimum and a user maximum.
ATTENTION:
Abracon LLC’s products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications. Abracon’s products
are not specifically designed for Military, Aviation, Aerospace, Life-dependent Medical applications or any application requiring high reliability where component failure could result in loss of life
and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization from Abracon LLC is required. Please contact
I am testing a board made with RM48 chip. The boards use CAN communication. However, the ID of the msg can be received at the receiving end, but the content of the msg cannot be received. What is goin...
My teacher asked me to write an SCI initialization code. After reading the documentation of this chip, I still feel confused. It’s due the day after tomorrow and I’m so anxious... I still can’t figure...
I recently encountered such a circuit. The power supply on the left. The switch gives a pulsed closing signal. What is the signal at both ends of L2? I still can't figure it out. Is there something wr...
rt, I use LPCxpresso compiler. #define NO_CRP 0xFFFFFFFF #define NO_ISP_MAGIC 0x4E697370 #define CRP1_MAGIC 0x12345678 #define CRP2_MAGIC 0x87654321 /**** DANGER CRP3 WILL LOCK PART TO ALL READS and W...
An embedded media processor is now capable of handling both MCU and DSP tasks, bringing C programmers familiar with MCU-based application development into a new realm where intelligent management of c...
[p=30, null, left][font=宋体][font=Verdana][size=3][color=#000000] The noise performance of the amplifier circuit is deeply affected by the thermal noise of the resistor (input resistor and feedback res...