DIP1989SD013653BD

Event: The company simultaneously released its 2017 annual report and the first quarter report of 2018. In 2017, the company achieved revenue of 8.886 billion yuan, a year-on-year increase of 48.01...[Details]

Recently, the results of the 2018 German Red Dot Design Award were announced. GoodWe, a company located in Suzhou High-tech Zone, stood out among thousands of outstanding design products from 5...[Details]

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

Since the first draft of the 5G NR standard was officially launched at the end of 2017 , the 5G commercialization process has taken a substantial step forward. From that moment on, mo...[Details]

In the Huaxing Optoelectronics LCD panel factory located in Guangming New District, Shenzhen , apart from a few people repairing machines, it is often difficult to see other people. Here, ev...[Details]

This program is used in the development board to generate sounds of different frequencies. The overall program is relatively simple, mainly using two timers. The code and my comments are as follows. ...[Details]

On the eve of 5G commercialization, ZTE has established and adhered to the 5G pioneer strategy, focusing on 5G end-to-end solutions, and investing in standard setting, ...[Details]

Household photovoltaic power stations mainly utilize idle resources on existing household buildings, such as roofs, wall facades, balconies, courtyards, etc., to install and use distributed photovo...[Details]

According to MEMS Consulting, single-chip radar system-on-chip (SoC) is becoming one of the most popular new sensors . Its widespread adoption in automobiles has greatly increased sales, thereby pr...[Details]

STM32F103 has dual DAC channels, using DMA to achieve 2 waveform outputs #include "stm32f10x.h"      //DAC1,2 initialization   void dac_init(void)   {       RCC- APB2ENR |= RCC_APB2ENR_IOPAEN; //Tu...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

#include reg52.h //Include the header file. Generally, no modification is required. The header file contains the definition of special function registers.                              /*-------------...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

Assume that the MCS-51 microcontroller uses a 12MHz crystal oscillator, and wants to use a timer to generate a pulse with a duty cycle of about 30% and a period of 60ms at port P1.0. ;==============...[Details]

Unfortunately, my serial port has some problems and I can't print information. I can only debug to view variables and see the values. Fortunately, there is not much AD conversion code, and I can use ...[Details]