177-714-2-21CS6J1-24PDN datasheet, PDF

Datasheet> All Categories > The connector> The connector> 177-714-2-21CS6J1-24PDN

177-714-2-21CS6J1-24PDN: DescriptionInterconnection Device; CategoryThe connector The connector; File Size436KB，4 Pages; ManufacturerGlenair; Websitehttp://www.glenair.com/

Download Datasheet Parametric View All

177-714-2-21CS6J1-24PDN Overview

Interconnection Device

177-714-2-21CS6J1-24PDN Parametric

Parameter Name	Attribute value
Reach Compliance Code	compli
Connector type	INTERCONNECTION DEVICE
Base Number Matches	1

Preview

Download Datasheet

View All

MWDM Micro-D Shielded Cable Assemblies

Single-Ended or Double-Ended–These

easy-to-order cable

assemblies eliminate the need for expensive assembly

labor. 100% tested and ready for use.

Now With Twisted Pairs–No

need to create a procurement

speciﬁcation for Micro-D cables with twisted pairs. Glenair

177-740 cables are furnished with a full complement of

white/blue twisted pair wires.

Integral Shield Termination–The

connector shell has a

platform to accept Band-It shield termination bands. The

cable shield braid is attached directly to the connector.

Save Labor, Reduce Weight and Improve EMI Shielding with

Glenair’s Micro-D Shielded Cable Assemblies

Aerospace electronics systems require higher and higher levels of protection from radiated emissions. Glenair’s fully

shielded Micro-D cable assemblies meet this need. The cable shield is attached directly onto the one-piece connector

shell and secured with a stainless steel

BAND-IT

® clamp. These pre-wired, 100% tested assemblies meet the

requirements of MIL-DTL-83513. An optional ground spring on the pin connector assures low shell-to-shell resistance.

Available with a variety of wire types and shields, Micro-D shielded assemblies can be ordered in any length, either

single-ended or “back-to-back”.

Ground Spring and EMI Shielding Effectiveness

– A gold-plated

stainless steel ground spring on the pin connector mating face offers

substantial improvement in EMI protection. The graphs compare

identical connectors tested with and without ground springs.

EMI Performance with Ground Spring

SHIELDING EFFECTIVENESS (DB)

100

1.00E+03

100

1.00E+03

EMI Performance without Ground Spring

1.00E+04

1.00E+05

1.00E+06

1.00E+07

1.00E+08

1.00E+09

1.00E+04

1.00E+05

1.00E+06

1.00E+07

1.00E+08

1.00E+09

FREQUENCY (Hz)

CAGE Code 06324/0CA77

Printed in U.S.A.

GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912

www.glenair.com

B-8

E-Mail: sales@glenair.com

Recommended Resources

Intermittent cycle control start and stop circuit 2

Y-△ starting circuit for frequently starting motors

repetitive timing circuit

Thermistor phase blocking protection circuit

STK0059 power amplifier circuit

One of the blind pathfinder circuits

PCBеEMC: [color=red][b]Please log in before downloading[/b][/color]...; 护花使者 FPGA/CPLD

How to use bdata?: uchar bdata LedState = 0xFF;sbit LedAh = LedState^0;sbit LedAl = LedState^1; sbit LedK = LedState^2;sbit LedM = LedState^3;uchar bdata KeySign; sbit FirstPress = KeySign^4; sbit AffirmPress = KeySign^...; 1614048761 MCU

Introduction to Power Factor Correction Technology in AC/DC Front-End Converter Modules: [i=s] This post was last edited by fish001 on 2019-5-20 22:28 [/i] [p=30, 2, left][size=4] By definition, the power factor (PF) of an AC power supply is defined as the ratio of the real power (watts) ...; fish001 Analogue and Mixed Signal

Does vxworks support hyperthreading/multithreaded cpu? What components are needed? Is there any difference between the upper layer software and single threaded cpu?: Does vxworks support hyperthreading/multithreaded cpu? What components are needed? Is there any difference between the upper layer software and single threaded cpu?...; fpgafuns Real-time operating system RTOS

How to see which registers are synthesized in Quartus II9.0, privileged brother Johnson: During the experiment, did you pay attention to the rtl code? I wrote the program according to his video, but some registers were missing. The methods on the Internet didn't work, and I didn't see it ...; prayer_hong FPGA/CPLD

The problem of porting DSP algorithms from PC.: I need to port an image processing program from PC to DSP . The DSP model is DM642. After modifying the C++ program on PC to compile under DSP , it still has problems when running. The ported program ...; 821165254 DSP and ARM Processors

Shortcut: A0 A1 A2 A3 A4 A5 A6 A7 A8 A9 AA AB AC AD AE AF AG AH AI AJ AK AL AM AN AO AP AQ AR AS AT AU AV AW AX AY AZ B0 B1 B2 B3 B4 B5 B6 B7 B8 B9 BA BB BC BD BE BF BG BH BI BJ BK BL BM BN BO BP BQ BR BS BT BU BV BW BX BY BZ C0 C1 C2 C3 C4 C5 C6 C7 C8 C9 CA CB CC CD CE CF CG CH CI CJ CK CL CM CN CO CP CQ CR CS CT CU CV CW CX CY CZ D0 D1 D2 D3 D4 D5 D6 D7 D8 D9 DA DB DC DD DE DF DG DH DI DJ DK DL DM DN DO DP DQ DR DS DT DU DV DW DX DZ

Popular Components