In your current project, there is an ADC interrupt cycle of 125us. A 1ms 1s timing flag is set in the interrupt, and then in the while loop of main, it is judged that when the flag expires, CAN data u...
1. Circuit 1. Minimum line width: 6mil (0.153mm). That is to say, if the line width is less than 6mil, it will not be produced (the minimum line width and line spacing of the inner layer of the multil...
I want to know the differences among kernel objects, such as Arcname, basenamedobjects, callback, device, etc., which are seen in Winobj. What are the differences among these kernel objects? It should...
Reprinted from: https://stor.zol.com.cn/769/7694090.htmlOn May 7, the low-key blue giant IBM announced a major breakthrough in chip manufacturing technology. According to them, it has created the worl...
[i=s]This post was last edited by paulhyde on 2014-9-15 09:52[/i] [url=http://www.dinghantech.com/chanpinfangan.asp?PotID=100&request_Style=2]High Frequency Switching DC Power Supply System[/url]...
Microchip's PIC18F46J50 is a low-power, high-performance 8-bit USB microcontroller (MCU) using nanoWatt XLP technology. The current in deep sleep mode can be as low as 13nA, the operating voltage i...[Details]
With the rapid development of science and technology, especially the widespread application of digital technology and various ultra-large-scale integrated circuits, electronic equipment, especially...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
introduction
For the voltage regulator modules (VRMs) that power the latest computer central processing units (CPUs), power supply designers have historically used multiphase interleaved b...[Details]
Two simple circuits are implemented to drive two LEDs from a battery powered microprocessor.
This design is based on a circuit that uses three resistors and a microprocessor I/O pin as an input h...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
Microcalorimetry
is used to determine energy relationships. Microcalorimetry techniques are often required when performing calorimetric experiments with small sample sizes or slow heating rat...[Details]
1 Introduction
Intelligent control instruments are one of the most commonly used controllers in industrial control. They are mainly aimed at a specific parameter (such as pressure, tempera...[Details]
introduction
MAX6636 is a multi-channel precision temperature monitor that can not only monitor local temperature, but also connect up to 6 diodes externally. Each channel has a programmable...[Details]
Printed circuit boards ( PCBs
)
are used in most electrical products
. If a PCB has low
insulation resistance
(IR), the performance of the circuits on the PCB will be greatly reduced...[Details]
Problems such as the depletion of natural resources, air pollution, traffic congestion, and rising fossil fuel prices have forced societies and individuals to seek alternative means of transportati...[Details]
Motors, especially those with brushes, generate a lot of noise. This noise must be dealt with if the appliance is to meet the requirements of EMC standards. The means to solve EMC are nothing more ...[Details]
With the widespread application of new services and technologies in the communications industry, the scale and capacity of operators' network construction are getting larger and larger, and the ris...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
