Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
Show off the small prize I received today, a travel socket. This is a socket adapter. It feels pretty good. I can take it with me when I go out for repairs in the future....
I want to compile an application written in evc into the kernel. I have found two methods so far. One is to modify the configuration file and write my path and executable file under the module of the ...
Xiao Mei has been working hard to systematically organize the development methods of Intel SoC FPGA. (YY self-entertainment). Problem Description: I was stuck for several years because of the interrup...
As the title says, I am a little confused about how Android phones can communicate with PCs using only one USB cable, and can also access the contents of a TF card in USB mode through a computer, with...
I have a new job, which requires me to complete a SOC bootloader, but I don't know how to write the bootloader firmware part. Is there any expert who can give me some guidance on what needs to be done...
Radio frequency identification (RFID) technology is a contactless automatic identification technology. Its basic principle is to use radio frequency signals and their spatial coupling and transmission...