Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[size=3]Good news for students in Wuxi. I just saw a piece of news that this year, Wuxi's free WIFI on buses has been fully launched. Wuxi will become the leading city in China for free WIFI services....
int Read_ Temp(void)//Start temperature conversion and read data before Temp; is lost, can you tell me what is going on? (DS18B20 temperature measurement program.C(71): error C129: missing ';' before ...
I use the serial debugging assistant on the PC to send 1 to the microcontroller, but the display is 0xF4, 2 is 0xF5, 3 is still 0xF5, and 4 is 0xF4 again. I think 1 should be 0x01 and 2 should be 0x02...
How much current is needed to reach 12V1.5a at the end? Let's discuss. Then, under safe conditions, what is the minimum diameter of single-strand copper wire? If you have a calculation formula, please...