Data are valid at +25°C, unless otherwise specified.
Parameter
Input
Nominal input voltage
Permanent input
voltage range (Ui)
Transient input voltage
Undervoltage lock-out
(UVLO)
Start up time
Reflected ripple current
Input current in short circuit
mode (Average)
No load input current
Primary Output
Output voltage *
Set Point accuracy
+ Line regulation
+ Load regulation
Output power **
Ripple output voltage ***
3,3V and 5V output
12V output
15V and 24V output
Trim function
Sense function
Secondary Output
Output voltage *
Set point accuracy
Output power**
Ripple output voltage ***
3,3V, 5V and +/-5V output
12V and +/-12V output
15V and +/-15V output
24V and +/-24V output
Line regulation
Load regulation ****
Ui min. to max.
75% load
Nominal
VDC
%
W
mVpp
mVpp
mVpp
mVpp
%
%
Ui min. to max.
Nominal
75% load
Ambient temperature : +25°c
Ui min. to max.
Maximum
25% to full load
Full temperature range
Maximum
Ui min. to max.
Ui nominal
Full load
BW = 20MHz
Ui nominal
Ui nominal
Maximum
Maximum
Maximum
Maximum
Minimum
Maximum
Minimum
VDC
%
W
mVpp
mVpp
mVpp
%
%
%
%
Conditions
Limit or
typical
Nominal
Min. - Max.
Maximum
Minimum
Maximum
Maximum
Maximum
Maximum
Maximum
Units
CGDM-H
Hi-Rel
Grade
CGDM-J
Full temperature range
Full temperature range
Full load (consult factory)
Threshold
Ui nominal
Nominal output
Full load : resistive
Ui nominal, full load at
switching freq. BW = 20MHz
Ui nominal
Short-circuit
Ui nominal
No load
VDC
VDC
VDC/S
VDC
VDC
ms
mApp
mA
mA
20
9-36
40/0,1
7
8,5
40
50
60
60
28
16-40
50/0,1
12
15
40
50
60
60
3,3V , 5V , 12V , 15V or 24V
Consult factory for other outputs
+/- 1
10, 20 or 30
(limited to respectively 2A, 4A or 6A max.)
+/- 1
4
40
50
60
+5
-5
+5
-5
40
50
60
+5
-5
+5
-5
3,3V , 5V , 12V , 15V or 24V
+/- 5V , +/- 12V , +/- 15V or +/- 24V
Consult factory for other outputs
+/- 2
10 or 20
(limited to respectively
2A, 4A max)
Ambient temperature : +25°c
Maximum
Ui nominal, 75% load
Full temperature range
Ui min. to max.
Ui nominal
Full load
BW = 20MHz
Ui min. to max.
Full load
Ui nominal
25% to full load
Maximum
Maximum
Maximum
Maximum
Maximum
Maximum
Maximum
+/- 2
10 or 20
(limited to respectively
2A, 4A max)
40
50
60
60
+/- 1
+/- 2,5
40
50
60
60
+/- 1
+/- 2,5
Note * : For proper operation the CGDI module requires to install a 22µF chemical or tantalum capacitance accross output terminals.
Note ** : For 9-36V inpt range, the power is derated at 80% at 9V and increases linearly to full power at 12V.
Note*** : The ripple output voltage is the periodic AC component imposed on the output voltage, an aperiodic and random component (noise) has also to be considered. This noise can
be reduced by adding an external capacitor (typically 10nF/rated voltage depending on isolation requirement) connected between the pin Gin and the pin Gout of the converter. This capacitor
should be layed-out as close as possible from the converter.
Note **** : For load regulation characteristics from 0% to full load, please contact factory.
What is the problem with the following program? Compilation prompt LCD1602.C(24): error C141: syntax error near ')' LCD1602.C(27): error C141: syntax error near 'data' LCD1602.C(53): error C211: call ...
[i=s]This post was last edited by baiweihu on 2014-2-28 17:48[/i] [font=新宋体][size=2][color=#000000]ARM+LINUX route, focusing on embedded Linux operating system and its application software development...
I wrote a WinCE program and the ctoolbar is at the top of the screen in VC6. Is the position correct? I can transfer the same code to VS2005 and the ctoolbar moves to the bottom of the screen. Is it b...
Please guide me. My initialization program is written like this.The clock is 8MHz.void IICInit(){P3SEL |= 0x06;UCB0CTL1 |= UCSWRST;UCB0CTL0 = UCMST + UCMODE_3 + UCSYNC;UCB0CTL1 = UCSSEL_2 + UCSWRST;UC...
[i=s] This post was last edited by paulhyde on 2014-9-15 09:35 [/i] Below are the reports and programs of the winning works of the Georgia Electronics Cup Competition. You can refer to them. There are...
TD-SCDMA (Time Division Synchronous Code Division Multiple Access) is one of the three major standards for the third generation of mobile communications. It is a communication standard with indepen...[Details]
Digital signal processors have efficient numerical computing capabilities and can provide a good development environment, while programmable logic devices have highly flexible configurability. This...[Details]
Until now, designers have faced a trade-off in ADC selection. Pipeline converters offer high resolution and wide dynamic range, but their power consumption is quite high. The alternative, discrete ...[Details]
No other sector is feeling the pressure for change more acutely than the healthcare industry. Healthcare organizations and services are desperate to reduce costs, but the challenge is to do so without...[Details]
Blood pressure is one of the important physiological parameters of the human body. Accurate measurement of it is conducive to early detection and identification of hypertension types, and to the pro...[Details]
Keeping the heart environment compact and warm is beneficial in most cases, but it’s another story for electronic heart scanners. When GE Healthcare was designing a scanner that was said to be the fas...[Details]
Overview
Bioelectric signals are very weak, and there is strong interference when detecting them. Therefore, there are many technical difficulties in designing high-quality bioelectric ampli...[Details]
With the development of automatic control technology, the application of precision air pressure generation and control technology is becoming more and more extensive. However, the traditional valve...[Details]
As the price of readers and tags decreases and the global market expands, the application of radio frequency identification (RFID) is increasing day by day. Tags can be powered by readers (passive ...[Details]
0Introduction
In oil drilling, accurate measurement of wellbore posture is the premise of wellbore trajectory control. To this end, this paper fully combines the advantages of single-chip ...[Details]
0 Introduction
SAA7111 is a programmable video processor produced by Philips. The chip integrates A/D and decoding functions. It has phase lock, automatic clamp, automatic gain control, cl...[Details]
As microcontrollers become less expensive and more powerful, electrical designers are finding it more cost-effective to use multiple small controllers in both single-board and multi-board systems. ...[Details]
In electronic measurement technology, frequency measurement is one of the most basic measurements. The commonly used frequency measurement method and period measurement method have great limitation...[Details]
introduction
Taking care of babies is very tiring because they wake up and sleep frequently, and activities such as feeding and changing clothes will take up a lot of adults' time and energy. ...[Details]
Preface
Phase-modulated pulse signals can achieve a large compression ratio. As a commonly used pulse compression signal, they are widely used in modern radar and communication systems. Wi...[Details]
51mcu
京公网安备 11010802033920号
EEWORLD
