EEWORLDEEWORLDEEWORLD

Part Number

Search

PHP00603E4990BBT1

Description
res 499 ohm 3/8W .1% 0603
CategoryPassive components   
File Size146KB,5 Pages
ManufacturerVishay
Websitehttp://www.vishay.com
Download Datasheet View All

PHP00603E4990BBT1 Overview

res 499 ohm 3/8W .1% 0603

PHP
www.vishay.com
Vishay Dale Thin Film
High Power Thin Film Wraparound Chip Resistor
FEATURES
PHP series chip resistors are designed with enlarged
backside terminations to reduce the thermal resistance
between the topside resistor layer and the solder joint on the
end users circuit board.
Actual power handling capability is limited by the end user
mounting process. As with any high power chip resistor the
ability to remove the generated heat is critical to the overall
performance of the device.
High purity ceramic substrate
Power rating to 2.5 W
Resistance range 10
to 30.1 k
Resistor tolerance to ± 0.1 %
TCR to ± 25 ppm/°C
Flame resistant UL 94 V-0
Power supplies
Power switching
Braking system
Test and measurement equipment
Motor deflection circuits
APPLICATIONS
TYPICAL PERFORMANCE
ABSOLUTE
TCR
TOL.
25
0.1
STANDARD ELECTRICAL SPECIFICATIONS
TEST
Material
Resistance Range
TCR: Absolute
Tolerance: Absolute
Power Rating: Resistor
Stability: Absolute
Stability: Ratio
Voltage Coefficient
Working Voltage
Operating Temperature Range
Storage Temperature Range
Noise
Shelf Life Stability: Absolute
SPECIFICATIONS
Nichrome
10
to 30.1 k
25 ppm/°C, 50 ppm/°C (standard)
and, 100 ppm/°C
0.1 %, 0.5 %, 1.0 % and, 5.0 %
0.375 W - 2.5 W
(1)
R
0.1 %
Not applicable
< 0.1 ppm/V
75 V to 200 V
-55 °C to +155 °C
-55 °C to +155 °C
< -30 dB
± 0.01 %
CONDITIONS
-
-
-55 °C to +125 °C
+25 °C
Maximum at +70 °C
2000 h at +70 °C
-
-
-
-
-
-
1 year at +25 °C
COMPONENT RATINGS
CASE SIZE
POWER RATING (mW)
0603
375
(1)
0805
625
(1)
1206
1000
(1)
2512
2500
(1)
Note
(1)
Dependent on component mounting by user.
WORKING VOLTAGE (V)
75
100
200
200
RESISTANCE RANGE ()
10 to 30.1K
10 to 30.1K
10 to 30.1K
10 to 30.1K
ENVIRONMENTAL TESTS
(Vishay Performance vs. MIL-PRF-55342 Requirements)
ENVIRONMENTAL TEST
Resistance Temperature Characteristic
Maximum Ambient Temperature at Rated Wattage
Maximum Ambient Temperature at Power Derating
Thermal Shock
Low Temperature Operation
Short Time Overload
High Temperature Exposure
Resistance to Soldering Heat
Moisture Resistance
Life at +70 °C for 2000 h
Revision: 27-Jun-16
LIMITS MIL-PRF-55342
CHARACTERISTIC “E”
± 25 ppm/°C
+70 °C
+150 °C
± 0.1 %
± 0.1 %
± 0.1 %
± 0.1 %
± 0.2 %
± 0.2 %
± 0.5 %
TYPICAL VISHAY PERFORMANCE
± 15 ppm/°C
+70 °C
+150 °C
± 0.04 %
± 0.001 %
± 0.003 %
± 0.030 %
± 0.007 %
± 0.002 %
± 0.100 %
Document Number: 60076
1
For technical questions, contact:
thinfilm@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT
www.vishay.com/doc?91000
How much does a cyclone chip usually cost?
How much does a cyclone chip usually cost?...
niaozaijiao FPGA/CPLD
Show off the 3-in-1 development board I drew
[i=s]This post was last edited by sfesdm on 2018-2-5 20:55[/i] I already have several development boards, including 254x, 264x and STM32. Because I need to switch between these development boards for ...
sfesdm Wireless Connectivity
Does the Chinese interface of ce6 conflict with activesync?
I used to use ce6 with English interface and there was no problem. I changed the interface to Chinese these days and found that activesync could not connect successfully. As soon as I connected the US...
wbq315 Embedded System
NUCLEO-G071RB Review: Serial Printing and LED Flashing
Test a cost-effective MCU . This MCU is definitely a must-have sword for embedded engineers. The most amazing thing is that ST company gives you the sword and also provides a sword manual to ward off ...
张jack stm32/stm8
MCU reset problem caused by relay pull-in
The microcontroller controls the relay to close through the transistor, driving the motor to rotate. At the moment the relay closes, the microcontroller resets. How can I solve this problem?...
qrnuyangfu Integrated technical exchanges
Self-made and debugged electron tube amplifier
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 19:57[/i]When making a tube amplifier, the following issues should be focused on. 1. Power supply system The quality of the power supply s...
lorant Mobile and portable

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 545  2180  2665  1196  1099  11  44  54  25  23 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号