ATC GENERAL PURPOSE CAPACITORS: NPO (COG) DIELECTRIC
ELECTRICAL CHARACTERISTICS
CAPACITANCE RANGE:
0.5 pF to 0.10 µF.
TEMPERATURE CHARACTERISTIC:
0 ± 30ppm/°C.
L
W
OPERATING TEMPERATURE RANGE:
-55°C to +125°C.
DISSIPATION FACTOR:
0.1% (max.) @ + 25°C,
@1 MHz
≤
1000 pF; @1 KHz >1000 pF
INSULATION RESISTANCE
@ + 25°C and rated Vdc:
100,000 megohms (min.) or 1000 ohm-farads (min.),
whichever is less.
DIELECTRIC WITHSTANDING VOLTAGE:
250% of rated voltage for 5 ± 1 seconds, 50 milliamps (max.).
Unless otherwise specified all test data is at + 25°C.
T (MAX.)
MB
Temperature Coefficient
Aging Rate
Voltage Coefficient of Capacitance
Temperature (Celsius)
Impedance vs. Frequency
Dissipation Factor vs. Frequency
Minimum IR vs. Temperature
Temperature (Celsius)
Sales of ATC products are subject to the terms and conditions contained in American Technical Ceramics Corp. Terms and Conditions of Sale(ATC document #001-992 Rev. A 10/03). Copies of
these terms and conditions will be provided upon request. They may also be viewed on ATC's website at www.atceramics.com/productfinder/default.asp. Click on the link for Terms and
Conditions of Sale.
ATC has made every effort to have this information as accurate as possible. However, no responsibility is assumed by ATC for its use, nor for any infringements of rights of third parties which
may result from its use. ATC reserves the right to revise the content or modify its product without prior notice.
[i=s]This post was last edited by michael_llh on 2016-8-2 09:35[/i] [font=新宋体][size=4] Now everyone should have received the UFUN learning board. In order to facilitate everyone's learning, here we ha...
I recently used 2812 and found two very puzzling problems. 1. I used 18K and 22K resistor divider network to convert 5V TTL signal into 3.3V TTL signal, but it didn't work at all. The low level turned...
Hello everyone, I am an absolute novice and rookie. I used to work in microwave design in Shanghai for more than two years, and then I returned to Dalian due to some family reasons. Dalian is more eng...
The basic principle of pulse width modulation (PWM): The control method is to control the on and off of the switching devices in the inverter circuit so that a series of pulses with equal amplitude ar...
This article is translated from Microwaves101 | Microwave Rules of Thumb, which summarizes some rules of thumb in microwave circuits. The so-called rules of thumb are some rules summarized over a long...
Here we introduce a simple and easy-to-make fun production - magic lamp. The circuit is shown in Figure 1. As long as you hold the magic wand with a permanent magnet in your hand and shake it from bot...