The properly and electrostatically measured taping materials are used for the components, but attention should be paid to the fact that there is some danger the parts absorb on the top
tapes to cause a failure in the mounting and the parts are destructed by static electricity (more than 1kV : 1J, 2A, 2B, 2E 0.5kV : 1E, Human Body Model 100pF 1.5kΩ) to change the
resistance in the conditions of an excessive dryness or after the parts are given vibration for a long time as they are packaged on the tapes. Similarly, care should be given not to apply the
excessive static electricity when mounting on the boards.
●
Ionic impurities such as flux etc. that are attached to these products or those mounted onto a PCB, negatively affect their moisture resistance, corrosion resistance, etc. The flux may
contain ionic substances like chlorine, acid, etc. while perspiration and saliva include ionic impurities like sodium (Na
＋
), chrorine (Cl
−
) etc. Therefore these kinds of ionic substances may
induce electrical corrosion when they invade into the products. Either thorough washing or using RMA solder and flux are necessary since lead free solder contains ionic substances.
Washing process is needed, before putting on moisture proof material in order to prevent electrical corrosion.
●
Please pay attention that the top of an iron does not direct touch to the components. There is a risk that may cause a change in resistance. Take care that another risk may happen that
the protecting coat is carbonized in an instant when touched directly by the top of the iron, also climatic-proof for electric corrosion or insulation of protecting coat may be dropped down.
Be sure not to give high temperature on the top of the iron as it will degrade the protecting coat.
●
Avoid storing components under direct sun rays, high temperature/humidity. Direct sun rays will cause quality change of taping and difficulty of keeping appropriate peeling strength. 5∼
35℃/35∼75%RH, there is no deterioration of solderability for 12 months, but take special care for storing, because condensation, dust, and toxic gas like hydrogen sulfide, sulfurous acid
gas, hydrogen chloride, etc. may drop solderability.
Hongmeng Development Board Neptune (Part 1) - Unboxing
Neptune is the cheapest OpenHarmony development board on the entire network. It is designed based on the Lianshengde W800 chip and is a cost-effe...
Is there anyone who has learned Multisim10? I want to draw components in it, but I can't find the spice model of the chip. What should I do? Please help me....
As shown in the figure above, the SDA signal of I2C communication, the two pictures above appear alternately, with a time interval of 200ms; the first picture shows that the high level of the command ...
Last time, I participated in the LM3S811 evaluation board, but the peripherals needed to be expanded by myself, which was not very convenient. I thought it would be better to make a baseboard, and the...
[i=s] This post was last edited by Lao Zhongyi Lai at 2021-6-20 09:13 [/i]This diode is marked with B95. The picture has been uploaded. Please help me check it. Thanks....
Embedded System
京公网安备 11010802033920号
EEWORLD
