Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
3998 Series 1550 nm
Externally-Modulated Transmitter
DATASHEET | OCTOBER 2013
CATV
S-Type
Property
Performance
(Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
L (km)
Units
3998-
SA1
65
NTSC 80
7.0/ 7.0
4
16.0
53.0/ 53.0
-65/ -65
-65
-64
Models
3998-SA2
65
PAL 60
7.0/ 7.0
5
16.0
53.0/ 53.0
-65/ -65
-65
-64
Comments
3998-SA4
65
PAL 89
7.0/ 7.0
5
16.0
50.0/ 50.0
-65/ -65
-65
-64
3998-SA3
65
NTSC 110
7.0/ 7.0
4
16.0
50.0/ 50.0
-65/ -65
-65
-64
3998-SA5
65
42 CENELEC
7.0/ 7.0
5
16.0
53.0/ 53.0
-65/ -65
-65
-64
Min.
Min.
Max.
Max. @ +25°C
Max. @ 0
o
C to 50
o
C
Min. - Higher Powers
Available See Chart
F-Type
Property
Performance (Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
Units
3998-F01
L (km)
20
NTSC 80-Ch
7.0/ 7.0
4
21.0
48.0
-58
-58
Models
3998-F02
3998-F03
20
PAL 60-Ch
7.0/ 7.0
5
21.0
48.0
-58
-58
20
NTSC 110-ch
7.0/ 7.0
4
21.0
45.0
-58
-58
Comments
3998-F04
20
PAL 89-Ch
7.0/ 7.0
5
21.0
45.0
-58
-58
Min.
Min.
Max.
Max.
Min.
N-Type
Property
Performance (Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
L (km)
Units
Models
3998-N01
3998-N02
40
NTSC 80-Ch
9.5
4
13.0
52.0
-62
-62
-61
40
PAL 60-Ch
9.5
5
13.0
52.0
-62
-62
-61
Min.
Min.
Max.
Min.
Comments
Max. @ +25°C
Max. @ 0
o
C to 50
o
C
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2General and Mechanical Specifications
8. With 36 QPSK modulated SAT-IF signals between 950 --- 2800 MHz, 27 MHz IF bandwidth.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Second free development board giveaway, 40mb development data package: examples, schematics, keil official version, free download Download 50 MCU program examples and development board schematics, Xue...
Attempt to send control codes to the filter driver using DeviceIoControl. The source code is as follows: #define START_FILTER CTL_CODE(FILE_DEVICE_CD_ROM_FILE_SYSTEM,XD_CTL_CODE_READONLY,METHOD_BUFFER...
Magnetic components, Chinese e-books, including transformers in switching power supplies, magnetic materials, inductors, high-frequency magnetic amplifiers, alloy magnetic materials, and some design a...
I looked at the file system support of uboot, and it supports a lot, including ext and fat. However, I think fat only supports reading and writing a file from the fat area, but some strings inside the...
[i=s]This post was last edited by paulhyde on 2014-9-15 09:47[/i]List of basic instruments and main components1. Basic Instrument List20MHz ordinary oscilloscope (dual channel, external trigger input,...
If the ultimate form of a car is a silicon-based life form, then in
the field of
intelligent driving
, it has gradually taken on the appearance of a "veteran driver." In
the field of
the ...[Details]
Wave soldering is a crucial electronic component soldering technique used in the production of a wide range of electronic devices, from home appliances to computers to avionics. The process is wide...[Details]
The mass production process of the new generation of cockpit platform has started, and the smart cockpit market has entered a new bonus cycle of technology iteration and platform upgrade.
...[Details]
New energy pure electric vehicles generally accelerate faster than comparable fuel-powered vehicles, both from a standing start and while accelerating. Many believe this is simply due to the motor'...[Details]
Multi-touch mobile phone
Multi-touch is a system that can respond to multiple touches on the screen at the same time. Multi-touch phones are divided into capacitive and resistive types. Capaci...[Details]
Recently,
Xpeng Motors and Xinlian Integrated Circuit jointly announced the mass production of China's first hybrid silicon carbide product.
Designed and developed by Xpeng Motors and joint...[Details]
As time goes by, people are increasingly concerned about their own and their families' health. However, existing monitoring devices for individual vital signs have struggled to gain market share du...[Details]
1. Multi-channel DAC technology bottleneck
Currently,
the development of multi-channel DAC technology focuses on two core challenges.
First, industrial applications urgently ...[Details]
The 2025 China International Automotive Testing Exhibition will be held at the Shanghai World Expo Exhibition and Convention Center from August 27 to 29, 2025.
Clacton Seafront, UK, ...[Details]
The MCX E series is the most reliability- and safety-focused series in NXP's extensive MCX product portfolio.
With the launch of this series, NXP has further enriched its 5V-compatible MCU pr...[Details]
According to foreign media reports, Ford Motor has applied to the U.S. Patent and Social Security Office (USPTO) for a patent for a door anti-collision system that may be used in future Ford vehicl...[Details]
In the period after the switching power supply achieved the "20 kHz" revolution in the 1970s, although improvements and enhancements were made in circuit technology, the development level of the se...[Details]
Common methods for troubleshooting roller press bearing wear include repair welding, thermal spraying, brush plating, and scrapping and replacement. However, these methods are often subject to asse...[Details]
Speaking of the problem of vehicle spontaneous combustion, whether it is a pure electric vehicle or a fuel vehicle, there will be incidents of spontaneous combustion. For the same spontaneous combu...[Details]
As a pioneer in the new smart home concept, robot vacuums have captured a significant market share. Robot vacuums, also known as automatic sweepers, smart vacuums, or robot vacuums, are smart home ...[Details]
Robotics Development
京公网安备 11010802033920号
EEWORLD
