The critical section in the program InitializeCriticalSection(&(pHWHead->RegCritSec)); .... DeleteCriticalSection(&(pHWHead->RegCritSec)); .... .... EnterCriticalSection(&(pHWHead->RegCritSec)); .... ...
When using stm8s_gpio.c to compile under Raisonance, the problem of not being able to find the stm8s_gpio.c file occurs. The reason is found in the following statement: void GPIO_WriteLow(GPIO_TypeDef...
#define AT91C_ID_IRQ1 ((unsigned int) 30) // Advanced Interrupt Controller (IRQ1) I use IRQ1, which is defined as up. So how much IRQ should I add to the registry? 1E or 30? I tried 1E and it didn't w...
This issue explains the design knowledge of positive and negative films in high-speed PCB design. 1. Negative film design requirements (1) It is recommended to select appropriate line width for the di...
As LEDs continue to improve in almost every aspect of performance and cost, LED lighting is being used in an increasingly wide range of applications, among which LED street lights are a focus of in...[Details]
The TPS92210 is a single-stage LED lighting pulse width modulation (PWM) controller. The TRIAC dimmable solution not only regulates the LED current, but also achieves a power factor close to 1. The...[Details]
D5026A is a driver IC designed by Shanghai Debei Electronics for energy-saving LED display screens. Its design concept is energy-saving and compatible with existing solutions, that is, it can be ...[Details]
Car lights, whether headlights, fog lights or tail lights, play an important role in driving safety. However, the material of the car lights determines that the probability of damage in a collision...[Details]
UDN2916LB is a two-phase stepper motor bipolar driver integrated circuit launched by SANKEN. It can drive dual-winding bipolar stepper motors and is particularly suitable for controlling dual-step ...[Details]
O Introduction
For people who are in the wild, a question that they are more concerned about is the altitude of the place where they are. However, there are very few such products on the mar...[Details]
The coking workshop of Tianjin No. 2 Gas Plant is the core of the whole plant's production and an important source of economic and social benefits. Its production automation level and management an...[Details]
1. Composition of product standard system
LED is a new type of lighting appliance product. LED products include the LED itself, the supporting control devices and the lighting products that us...[Details]
In recent years, information technology based on microelectronics and computer technology has developed rapidly, and ultrasonic non-destructive testing instruments have also gained unpreceden...[Details]
1. Architecture and operation of electronic toll collection system
The basic principle of the electronic toll collection system is to enable a special device (on-board unit) installed on t...[Details]
As the trend towards miniaturization continues, new packaging methods and methods of interconnecting integrated circuits have been developed. Today, "system on chip" refers to a packaging method th...[Details]
Motor vehicle garage management and control system
I. Usage requirements
1. There are 70 parking spaces in the garage, and each parking space is equipped with a door at the entrance. Ther...[Details]
Abstract: Based on CPLD as the core, a manageable SAS hard disk backplane is designed. While conveniently replacing the faulty hard disk, it can indicate the working status of the hard disk by cont...[Details]
Supercapacitor is a new type of power storage device that has only been mass-produced in recent years, also known as electrochemical capacitor. It has the advantages of high discharge power of electro...[Details]
introduction
Analog-to-digital conversion is a technology that converts analog input signals into N-bit binary digital output signals. Digital signal processing can easily implement variou...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
