Capacitance Change with Reference to +25°C and 0 VDC Applied (TCC)
Aging Rate (Maximum % Cap Loss/Decade Hour)
Dielectric Withstanding Voltage
Dissipation Factor (DF) Maximum Limits @ 25ºC
Insulation Resistance (IR) Limit @ 25°C
-55°C to +125°C
±15%
3.0%
250% of rated voltage
(5 ±1 second and charge/discharge not exceeding 50 mA)
See Dissipation Factor (DF) Limits Table
See Insulation Resistance Limit Table
(Rated voltage applied for 120 ±5 seconds @ 25°C)
Parameters/Characteristics
Regarding aging rate: Capacitance measurements (including tolerance) are indexed to a referee time of 48 or 1,000 hours. Please refer to a part number specific
datasheet for referee time details.
To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.
Capacitance and dissipation factor (DF) measured under the following conditions:
1 kHz ±50 Hz and 1.0 ±0.2 Vrms if capacitance ≤ 10 µF
120 Hz ±10 Hz and 0.5 ±0.1 Vrms if capacitance > 10 µF
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as
Automatic Level Control (ALC). The ALC feature should be switched to "ON."
When I compile with PIC18F6520, although the compilation is successful, the following problem occurs. Could you please help me figure out what this means and how to solve it? Thank you in advance. Adv...
[i=s]This post was last edited by Pinghu Qiuyue on 2016-3-8 10:10[/i] Look at this picture, Proteus 8.4 is amazing, it directly generates its code in the form of a flowchart!...
If you are a hardware engineer who wants to play with Bluetooth, and you don't know the various interfaces on the Bluetooth module, then you are not a qualified hardware engineer. Do you have a thorou...
As we all know, China's enterprise computing market will usher in an unprecedented lively scene in September. AMD will release its most important product in four years on September 10, the quad-core s...
It is very simple, only three wires are needed: GND, TMS, RST. In addition, the MCU on the LaunchPad should be removed, and the other circuits should remain unchanged.
This is my experiment of debuggi...