Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Revision History ......................................................................................................................................................................... 15
Rev 0.5
Page 2 of 18
www.sitime.com
SiT9347
220 MHz to 725 MHz Endura™ Series Ultra-low Jitter Differential Oscillator
Electrical Characteristics
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage
with standard output termination shown in the termination diagrams. Typical values are at 25°C at nominal supply voltage.
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-10
Typ.
–
–
Max.
725
+10
Unit
MHz
ppm
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated power
supply voltage and load variations.
Contact SiTime
for ±10 ppm.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage and load variations
Frequency Range
Frequency Stability
-20
-25
-50
First Year Aging
10 Year Aging
20 Year Aging
F_1y
F_10y
F_20y
-0.7
-1.4
-1.6
–
–
–
±0.4
±0.8
±1.0
+20
+25
+50
+0.7
+1.4
+1.6
ppm
ppm
ppm
ppm
ppm
ppm
At 85°C
At 85°C
At 85°C
Temperature Range
Operating Temperature Range
T_use
-20
-40
-40
-40
Acceleration (g) sensitivity,
Gamma Vector
Supply Voltage
F_g
–
–
–
–
+70
+85
+95
+105
°C
°C
°C
°C
Extended Industrial
Low sensitivity grade; total gamma over 3 axes; 15 Hz to 2 kHz; MIL-
PRF-55310, computed per section 4.8.18.3.1
Extended Commercial
Industrial
Rugged Characteristics
–
–
0.1
ppb/g
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
OE Enable/Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
3.30
3.00
2.80
2.50
–
–
100
–
–
–
3.63
3.30
3.08
2.75
–
30%
-
55
3.0
3.8
V
V
V
V
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches rated
VIH and VIL to the time clock pins reach 90% of swing and high-Z.
See
Figure 8
and
Figure 9
Pin 1, OE
Pin 1, OE
Pin 1, OE logic high or logic low
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 0.5
Page 2 of 18
www.sitime.com
SiT9347
220 MHz to 725 MHz Endura™ Series Ultra-low Jitter Differential Oscillator
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[3]
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
Min.
–
–
–
–
Vdd-1.15
Vdd-2.0
1.2
–
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
0.220
Max.
94
63
–
33
Vdd-0.7
Vdd-1.5
2.0
330
1.6
0.270
Unit
mA
mA
A
mA
V
V
V
ps
Ps
Ps
Condition
Excluding Load Termination Current, Vdd = 3.3V or 2.5V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 4
See
Figure 4
See
Figure 5
20% to 80%, see
Figure 5
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3V or 2.5V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs. Temperature ranges -20 to 70ºC and
-40 to 85ºC.
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -40 to 95ºC and
-40 to 105ºC
f = 322.265625 MHz, IEEE802.3-2005 10GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, Includes spurs, all
Vdd levels
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3V or 2.5V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs. Temperature ranges -20 to 70ºC and
-40 to 85ºC.
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -40 to 95ºC and
-40 to 105ºC
f = 322.265625 MHz, IEEE802.3-2005 10GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, Includes spurs, all
[b]1. Why is it that when I place a rectangle or rounded rectangle, it is sometimes just a box? [/b] Answer: It may be related to our default settings, which have been adjusted. In fact, you can chang...
I searched for 18B20 information online, and all of them were multi-interface methods, that is, sending CC to skip ROM instructions. Few people have studied 55 matching ROM instructions, and it was di...
[i=s] This post was last edited by paulhyde on 2014-9-15 09:35 [/i] [font=宋体][size=14.0pt] (1) Count seconds, minutes and hours, and switch between 24-hour and 12-hour systems; [/size][/font] [font=宋体...
Maybe the previous topic was not very clear. I just want to use the hysteresis comparator idea to achieve high-sensitivity control, or the filtering idea, PID idea. I am not sure whether this idea is ...
The fault phenomenon is: select options for target "target1", enter the debug menu, select "keil monitor-51driver" to enter the settings, after normal settings, it shows "monitor-51 not connected" in ...
Controller Area Network (CAN) is a type of fieldbus. It is a serial communication network that effectively supports distributed control or real-time control and is recognized as one of the most pro...[Details]
Due to the needs of medical development, in many cases, general thermometers can no longer meet the requirements of fast and accurate temperature measurement, such as measuring human body temperature ...[Details]
The small size and low cost of home appliance control boards mean that high-cost materials will not be used in the circuit to solve the electromagnetic interference problem. The interference of hom...[Details]
Multiple Input and Multiple Output (MIMO) technology is arguably the next most important development in wireless communications since the advent of digital communications. Many new wireless commun...[Details]
Among the many candidate standards for China's mobile TV, the CMMB standard proposed by the Broadcasting Science Research Institute of the State Administration of Radio, Film and Television is aime...[Details]
Most
embedded
systems are powered from a 48V backplane. This voltage is typically stepped down to a lower intermediate bus voltage of 24V, 12V, or 5V to power the circuit board racks withi...[Details]
With the advent of the new economic era represented by the Internet, PCs have lost their former glory, and smart 3C products (Computer, Communication and Consumer) will set off a new wave. As one o...[Details]
Anyone who has owned a laptop computer will have noticed that when running on battery power, their portable device behaves differently than when running on AC mains power—the display dims, the proc...[Details]
Abstract: This paper introduces the controller, interface, display principle and driving method of the handheld computer LCD display based on the SA1110 microprocessor. Combined with the HPC projec...[Details]
This paper introduces the technology and application of optical transceiver modules and digital non-volatile variable resistors in optical communication networks, and focuses on the design and appl...[Details]
1. Introduction
Most of the existing heaters use traditional devices such as electric heating tubes and electric heating wires for heating. The outer shell of the electric heating tube is a ...[Details]
Today, many wireless devices combine GSM, WCDMA, Bluetooth, WLAN, GPS and FM technologies and support the high data rates required for mobile Internet. Moreover, as customers demand mobile wireless...[Details]
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, as more safety electronic devices, fuel consumption and fuel emission control electronic s...[Details]
After being widely adopted in applications such as backlighting of portable products with small and medium-sized screens, light-emitting diodes (LEDs) have entered the field of general lighting in ...[Details]
Analysis of automotive sensor testing requirements
At present, the control system used in automobiles can be functionally divided into three parts: sensor unit, control unit and execution ...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
