The properly and electrostatically measured taping materials are used for the components, but attention should be paid to the fact that there is some danger the parts absorb on the top
tapes to cause a failure in the mounting and the parts are destructed by static electricity (more than 1kV : 1J, 2A, 2B, 2E 0.5kV : 1E, Human Body Model 100pF 1.5kΩ) to change the
resistance in the conditions of an excessive dryness or after the parts are given vibration for a long time as they are packaged on the tapes. Similarly, care should be given not to apply the
excessive static electricity when mounting on the boards.
●
Ionic impurities such as flux etc. that are attached to these products or those mounted onto a PCB, negatively affect their moisture resistance, corrosion resistance, etc. The flux may
contain ionic substances like chlorine, acid, etc. while perspiration and saliva include ionic impurities like sodium (Na
＋
), chrorine (Cl
−
) etc. Therefore these kinds of ionic substances may
induce electrical corrosion when they invade into the products. Either thorough washing or using RMA solder and flux are necessary since lead free solder contains ionic substances.
Washing process is needed, before putting on moisture proof material in order to prevent electrical corrosion.
●
Please pay attention that the top of an iron does not direct touch to the components. There is a risk that may cause a change in resistance. Take care that another risk may happen that
the protecting coat is carbonized in an instant when touched directly by the top of the iron, also climatic-proof for electric corrosion or insulation of protecting coat may be dropped down.
Be sure not to give high temperature on the top of the iron as it will degrade the protecting coat.
●
Avoid storing components under direct sun rays, high temperature/humidity. Direct sun rays will cause quality change of taping and difficulty of keeping appropriate peeling strength. 5∼
35℃/35∼75%RH, there is no deterioration of solderability for 12 months, but take special care for storing, because condensation, dust, and toxic gas like hydrogen sulfide, sulfurous acid
gas, hydrogen chloride, etc. may drop solderability.
I want to use CH1 of TIM3 to capture pulses, but the counter TIM3_CNT is only 16 bits, so pulses below 1.1KHz cannot be captured at 72M main frequency. I want to use the overflow flag of the counter t...
[LPC54100] M4 flashes, M0 flashes too. The first effect: Let M4 and M0 use GPIO to drive the LEDs respectively, and flash! Hardware: M04 onboard D2, blue M4 extended LED, P04 Program: Based on the M4 ...
[b] The UDP client of the LwIP API interface of LM3S9B92 under the ucos-ii operating system can ping successfully, but no data can be received on the PC. The source code is as follows: [/b] void UDP_T...
When I was selecting an ADC, I found that there was an analog filter group delay in the parameters. Will this have any impact on my data collection? I need to collect data every 20us? This group delay...
FPGA/CPLD
京公网安备 11010802033920号
EEWORLD
