Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[i=s]This post was last edited by paulhyde on 2014-9-15 03:58[/i] As the title says, I would like to know what the experts think of this year's control questions. Do you have any experience worth shar...
I am a student, and now I am doing a graduation project on a smart home control system, which is based on arm9 wince. I wonder if anyone has done it, and I hope you can teach me! ~~~...
Introduction and analysis of traditional secondary frequency conversionThe traditional GSM cellular phone is a transceiver working in duplex mode. A mobile phone generally includes a radio frequency p...
I signed a labor contract, a confidentiality agreement and annexes, and the clauses in them are too harsh. Comrade Xiang Nong is right, all crows are the same. :(" /> :(" /> [[i] This post was last ed...
Hello everyone: I recently used KEIL V3 to run a code. I set a breakpoint and used the Run command to run to the breakpoint. I want to see the specific values of each variable at the breakpoint. How c...
[color=#000000]I am planning to buy a signal generator. It doesn’t have to be expensive, under 800. The ones I see more often on the market are [color=red]Shenzhen Shengli[/color][color=red]Hong Kong ...
Electronics Design Contest
京公网安备 11010802033920号
EEWORLD
