Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
My touch screen (DOP-B07S201) does not respond to touch, but the buttons below work. I turn on the touch mouse, but my hand does not click. The touch test in the system settings does not respond eithe...
The stepper motor automatically rotates forward and reverse to the position and returns to the origin. There are four buttons in total. One, stop after forward rotation. Two, stop after reverse rotati...
[font=微软雅黑][size=5][color=#0000ff]When we were children, we wanted to do something, but sometimes our parents didn't support us. They didn't believe in our abilities, and they didn't want their childr...
How should the GPIO pins of a chip be configured if they are not used? For example, how should input pins, output pins, and bidirectional pins be set?...