[i=s]This post was last edited by qwerghf on 2017-10-30 00:05[/i] I have been too busy with work recently. I can only study before going to bed at night and go out to debug the LORA program on weekend...
I am making a PCI driver, using VC6 DDK. The bridge chip of the board is 9052. I set the interrupt in the driver, but there is no response. Why? I connected the LINTi1 of 9052 to a switch to simulate ...
[i=s]This post was last edited by paulhyde on 2014-9-15 03:05[/i] Here are some numbers. Among the 7 questions, there are 2 groups that ranked first, namely Huazhong University of Science and Technolo...
The course design is to make a frequency meter. Now the only thing missing is the pre-amplifier and shaping circuit. The requirements are 1hz-1Mhz, amplitude 0.5v----5v, and output TTL level. Does any...
A novice needs advice. Figure 1 is the serial port settings, and Figure 2 is the interrupt call function of serial port 0. Every time the serial port receives a data, this function is called once to p...
[i=s] This post was last edited by janeff on 2017-4-29 13:30 [/i] Why can't the two extreme values 0% and 100% be reached when outputting the waveform?...