clocks (RTCs) are designed to be direct replacements
for the DS1285 and DS1287. The devices provide a
real-time clock/calendar, one time-of-day alarm, three
maskable interrupts with a common interrupt output, a
programmable square wave, and 114 bytes of battery-
backed static RAM (113 bytes in the DS12C887 and
DS12C887A). The DS12887 integrates a quartz crystal
and lithium energy source into a 24-pin encapsulated
DIP package. The DS12C887 adds a century byte at
address 32h. For all devices, the date at the end of the
month is automatically adjusted for months with fewer
than 31 days, including correction for leap years. The
devices also operate in either 24-hour or
12-hour format with an AM/PM indicator. A precision
temperature-compensated circuit monitors the status of
V
CC
. If a primary power failure is detected, the device
automatically switches to a backup supply. A lithium
coin-cell battery can be connected to the V
BAT
input
pin on the DS12885 to maintain time and date operation
when primary power is absent. The device is accessed
through a multiplexed byte-wide interface, which sup-
ports both Intel and Motorola modes.
Features
♦
Drop-In Replacement for IBM AT Computer
Clock/Calendar
♦
RTC Counts Seconds, Minutes, Hours, Day, Date,
Month, and Year with Leap Year Compensation
Through 2099
♦
Binary or BCD Time Representation
♦
12-Hour or 24-Hour Clock with AM and PM in
12-Hour Mode
♦
Daylight Saving Time Option
♦
Selectable Intel or Motorola Bus Timing
♦
Interfaced with Software as 128 RAM Locations
♦
14 Bytes of Clock and Control Registers
♦
114 Bytes of General-Purpose, Battery-Backed
RAM (113 Bytes in the DS12C887 and
DS12C887A)
♦
RAM Clear Function (DS12885, DS12887A, and
DS12C887A)
♦
Interrupt Output with Three Independently
Maskable Interrupt Flags
♦
Time-of-Day Alarm Once Per Second to Once
Per Day
♦
Periodic Rates from 122μs to 500ms
♦
End-of-Clock Update Cycle Flag
♦
Programmable Square-Wave Output
♦
Automatic Power-Fail Detect and Switch Circuitry
♦
Optional 28-Pin PLCC Surface Mount Package or
32-Pin TQFP (DS12885)
♦
Optional Encapsulated DIP (EDIP) Package with
Integrated Crystal and Battery (DS12887,
DS12887A, DS12C887, DS12C887A)
♦
Optional Industrial Temperature Range Available
♦
Underwriters Laboratory (UL) Recognized
DS12885/DS12887/DS12887A/DS12C887/DS12C887A
Applications
Embedded Systems
Utility Meters
Security Systems
Network Hubs, Bridges, and Routers
Typical Operating Circuit
CRYSTAL
V
CC
X1
AS
R/W
DS
X2
V
CC
RESET
RCLR
DS83C520
CS
AD(0–7)
IRQ
MOT
DS12885
SQW
V
BAT
GND
Pin Configurations and Ordering Information appear at end of data sheet.
______________________________________________
Maxim Integrated Products
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
Real-Time Clock
DS12885/DS12887/DS12887A/DS12C887/DS12C887A
ABSOLUTE MAXIMUM RATINGS
Voltage Range on V
CC
Pin Relative to Ground .....-0.3V to +6.0V
Operating Temperature Range ...................................................
Commercial (noncondensing) .............................0°C to +70°C
Operating Temperature Range ...................................................
Industrial (noncondensing)...............................-40°C to +85°C
Storage Temperature Range .............................-55°C to +125°C
Soldering Temperature .......................................See IPC/JEDEC
J-STD-020 Specification (Note 1)
Soldering Temperature (leads, 10s) ................................+260°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
DC ELECTRICAL CHARACTERISTICS
(V
CC
= +4.5V to +5.5V,
T
A
= over the operating range, unless otherwise noted.) (Note 2)
As the title says, I want a 100mV reference voltage for AD. I built one today using TL431, but when I looked at the output voltage with an oscilloscope, there was about 4mV of ripple. The circuit is a...
I have encountered such a situation. I can use JTAG to download to the FPGA and download to flash, but I cannot import the configuration data from flash into the FPGA after powering on.
I checked for ...
I am a beginner, and I would like to ask you a question about Flash reading and writing. In ADuc702x, Flash is uniformly addressed, and the data of Flash can be read directly using ARM instructions. C...
The communication between the MCU and the touch chip is realized through the SMBus serial communication based on C8051F. The MCU is the host and the chip is the slave. Why does the reset of the host c...
As a wireless broadband metropolitan area network standard, WiMAX technology has greater advantages than previous 3.5GHz MMDS products in terms of non-line-of-sight transmission and spectrum utiliz...[Details]
System design is a complex process. It is not enough to just use ICs. There are many details to consider. This article uses a high-fidelity music playback system as an example to introduce how to s...[Details]
To differentiate their products in a crowded and competitive market, manufacturers of handheld devices often consider battery life and power management as key selling points for cell phones, PDAs, ...[Details]
Power management solutions for today's portable application processors are becoming increasingly integrated. Total power consumption, standby and sleep current consumption affect battery size, bill...[Details]
July 11, 2012, Beijing - Altera Corporation (NASDAQ: ALTR) today announced the launch of 40-Gbps Ethernet (40GbE) and 100-Gbps Ethernet (100GbE) intellectual property (IP) core products. These core...[Details]
1. What is temperature?
Heat is a type of molecular motion. The hotter an object is, the faster its molecules move. Absolute zero is defined as the temperature at which all molecular motion ...[Details]
A standard cell
is an electrochemical
cell
used as a voltage reference standard in many electrical standards laboratories
. If properly maintained, standard cells are very stable. The ...[Details]
1. System Structure
This system is a simulation system of indoor air-conditioning temperature/humidity control system. The data acquisition and control center collects temperature/humidity...[Details]
In the single-chip microcomputer system, in addition to display devices, sound devices are often used, and the most common sound device is the buzzer. Buzzers are generally used for some low-demand...[Details]
Experimental tasks
A DS18B20 is used to form a temperature measurement system. The temperature measurement accuracy reaches 0.1 degrees. The temperature range is between -20 degrees and +50 de...[Details]
Among the many members of the single-chip microcomputer family, the MCS-51 series of single-chip microcomputers has occupied the main market of industrial measurement and control and automation eng...[Details]
From the previous section, we have learned that the timer/counter in the microcontroller can have multiple uses, so how can I make them work for the purpose I need? This requires setting the timer/...[Details]
In 2012, more than half of the cars in the European, Japanese and American car markets will be equipped with color displays, navigation systems, satellite communications and other in-vehicle infota...[Details]
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guangzho...[Details]
Analog electronics
京公网安备 11010802033920号
EEWORLD
