895-038-523-407

As the number of cars increases, environmental pressures are also increasing. At this time, some people are saying that new energy vehicles are energy-efficient and environmentally friendly, and ar...[Details]

We are entering a new era where people are increasingly affordably equipped with more electronic gadgets. Electronics have become essential to our lives. For example, the average consumer now owns ...[Details]

Cadence and NVIDIA Collaborate to Revolutionize Power Analysis Technology, Accelerating Development of Billion-Gate AI Designs Cadence's new Palladium Dynamic Power Analysis applicat...[Details]

Generally not, but there are exceptions. For example, a torque motor controller with three-phase output voltage imbalance can cause current imbalance, similar to a phase loss. However, only two pha...[Details]

Recently, I received a request to use OK1028A-C to output PWM square wave. However, I found that there was no relevant instructions on the OK1028 platform, so I started writing this article. A...[Details]

On August 19, Huawei's Executive Director and Chairman of the Device BG, Richard Yu, shared a Weibo post about a conversation he had with a Zunjie S800 owner. The owner had driven over 5,000 kilome...[Details]

What is the difference in response time when the output uses cyclic refresh and direct refresh? The time required from when the PLC receives an input signal to when the PLC outputs a con...[Details]

As systems become increasingly used in industrial environments, industry safety requirements, as well as national and international safety regulations, need to be constantly updated to ensure a saf...[Details]

3D-SLISE, a quasi-solid-state electrolyte developed by the Institute of Science Tokyo, enables the production of safe and fast-charging 2.35 V lithium-ion batteries at room temperature and pressure...[Details]

1. One-way starting control circuit 1. Circuit operation analysis 1) Close the power switch QS and press the start button SB2. The contactor coil KM is energized, the normally open ...[Details]

1. How vibration sensors measure vibration Vibration sensors are mainly used in gas equipment. They can sense disasters such as earthquakes and cut off gas or power supply in time to prevent s...[Details]

Recently, a friend asked in the background: the recently released Yangwang U8L uses the RoboSense M1P, a long-range LiDAR, for its lateral LiDAR, while the Zunjie Wenjie series uses a TOF solid-sta...[Details]

Once the half-year data on power batteries came out, the situation became clearer. According to the latest data from South Korean research firm SNE Research, global installed capacity of...[Details]

Many automakers use 0-60 mph acceleration as a selling point for electric vehicles. It's the most direct indicator of a vehicle's power. This 0-60 mph acceleration is crucial for electric vehicles,...[Details]

LCOS (Liquid Crystal on Silicon) is a new reflective micro LCD projection technology that uses a CMOS integrated circuit chip coated with liquid crystal silicon as the substrate for the reflectiv...[Details]